Using Sleep Timer. JVC SP-MXK50, MX-K50

4

Set the on-time you want the unit to turn on.

1) Press 4 or ¢ to set the hour, then press SET.

2) Press 4 or ¢ to set the minute, then press SET.

“OFF TIME” appears for 2 seconds, then the unit enters off-time setting mode.

5

Set the off-time you want the unit to turn off (on standby).

1) Press 4 or ¢ to set the hour, then press SET.

2) Press 4 or ¢ to set the minute, then press SET.

The unit enters preset station selecting mode.

6

Select the preset station.

1) Press

4 or ¢ to select the band

(“TUNER FM” or “TUNER AM”), then press SET.

2) Press

4 or ¢ to select a preset channel number, then press SET.

The REC (recording timer) indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence for your confirmation.

SET

SET

SET

Using Sleep Timer

With Sleep Timer, you can fall asleep to music.

You can set Sleep Timer when the unit is turned on.

How Sleep Timer actually works

The unit automatically turns off after the specified time length passes.

On the remote control ONLY:

1

Press SLEEP.

The time length until the shut-off time appears and the SLEEP indicator starts flashing on the display.

• Each time you press the button, the time length changes as follows:

SLEEP

SLEEP10 SLEEP20 SLEEP30 SLEEP60

OFF SLEEP120 SLEEP90

(Canceled)

2

Wait for about 3 seconds after specifying the time length.

The SLEEP indicator stops flashing and remains lit.

To check the remaining time until the shut-off time, press SLEEP once so that the remaining time until the shutoff time appears for about 3 seconds.

To change the shut-off time, press SLEEP repeatedly until the desired time length appears on the display.

To cancel the setting, press SLEEP repeatedly until “OFF” appears on the display so that the SLEEP indicator goes off from the display.

• Sleep Timer is also canceled when you turn off the unit.

7

Press STANDBY/ON to turn off the unit (on standby) if necessary.

STANDBY

STANDBY/ON

Timer Priority

About the recording source

If you change the source while recording, the recording also changes.

To turn on or off Recording Timer after its setting is done

1 Press CLOCK/TIMER repeatedly until

“REC” appears on the display.

CLOCK

/ TIMER

2 To turn off the Recording Timer, press

CANCEL/DEMO.

The REC (recording timer) indicator goes off from the display (“OFF” appears for a while).

The Recording Timer is canceled, but the setting for the Recording Timer remains in memory until you change it.

To turn on the Recording Timer, press SET.

The REC (recording timer) indicator lights up on the display. The settings you have done are shown on the display in sequence for your confirmation.

CANCEL

/ DEMO

SET

– 23 –

Since each timer can be set separately, you may wonder what happens if the setting for these timers overlaps.

Here are some examples.

• Recording Timer has priority over Daily Timer.

If Recording Timer is set to come on while Daily Timer is operating, Daily Timer is canceled and Recording Timer start working.

6:00 6:30 7:00 7:30

Recording Timer

Daily Timer canceled.

• If Sleep Timer overlaps with another timer (either Daily

Timer or Recording Timer), a timer with the earlier shutoff time has priority.

21:00 21:30 22:00 22:30

Sleep Timer

Recording Timer canceled.

When using the Recording Timer and Sleep Timer at the same time, pay special attention to the shut-off time.

EN18-26.MX-K50[U].pm6

23 02.5.21, 11:21 AM