advertisement
20
CHAPTER 8: TROUBLESHOOTING
8.3 TROUBLESHOOTING - ERROR 04A0 / 0440
ERROR CODE 04A0 / 0440
1) SYMPTOM:
04A0 – UCB communication disconnected.
0440 – Timeout receive packet (LCB can not receive any data for 50 seconds).
2) SOLUTION:
If the display is giving a 04A0 error, check the LCB LED10 status.
- LED10 blinking: Turn off power and after 3 seconds, turn on power again. If console also show the 04A0, re-install UCB software again. If this does not resolve the issue, replace the UCB.
- LED10 off: Check the connection of the digital communication wire at the UCB and LCB (Figures A & B). If the connection is good, replace the digital communication wire.
- If replacing the UCB and digital communication wire does not work, replace the LCB.
FIGURE A FIGURE B
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 4 CHAPTER 1: SERIAL NUMBER LOCATION
- 6 Read and Save These Instructions
- 7 Electrical Requirements
- 8 Recommended Cleaning Tips
- 8 Check for Damaged Parts
- 9 Care and Maintenance Instructions
- 10 Console Description
- 11 Workout Setup Steps - Manual
- 11 Workout Setup Steps - Fat Burn
- 11 Workout Setup Steps - Level Based
- 12 Workout Setup Steps - Fitness Test
- 13 Workout Setup Steps - Target Heart Rate
- 13 Workout Setup Steps - Constant Watts
- 14 Using Manager Mode
- 14 Manager Mode Overview
- 15 Using Engineering Mode
- 16 Using Service Mode
- 17 Electrical Diagram
- 22 LCB LED Indicators
- 23 Troubleshooting - Error 04A
- 24 Troubleshooting - Error 04B
- 25 Troubleshooting - Error
- 26 Troubleshooting - Error 02B4 / 03A8 / 02AB
- 27 Troubleshooting - Error 0149 / 01AF
- 28 Troubleshooting - Error 01B
- 29 Troubleshooting - No Resistance
- 30 Troubleshooting - Heart Rate Issues
- 31 Troubleshooting - No Power to the Console
- 32 Troubleshooting - Keypad Issues
- 33 Console Replacement
- 34 Handlebar Replacement
- 35 Cup Holder Replacement
- 36 Keypad / Overlay Replacement
- 38 Seat Pad Replacement
- 39 Back Pad Replacement
- 40 HR Grips Replacement
- 41 Seat Set Replacement
- 42 Seat Slide Replacement
- 44 Rear Covers Replacement
- 45 Guide Rail Set Replacement
- 46 Pedal Replacement
- 47 Crank Axle Set Replacement
- 48 Front Shrouds Replacement
- 49 Front Covers Replacement
- 50 Console Mast Removal
- 51 Lower Control Board Replacement
- 52 Battery Replacement
- 53 Drive Belt Replacement
- 54 Generator Replacement
- 55 Rear Stabilizer Replacement
- 56 Front Stabilizer Replacement
- 57 Drive Axle Set Replacement
- 61 Testing the Bike
- 62 R5x-05 Bike Specifications
- 63 Assembly Instructions
- 70 Adjusting the Pedal Straps and Seat
- 71 Leveling the Bike
- 77 Software Upgrade Procedure