Bracket Mount Installation. Brant Radiant Heaters LR-LB1 Series
Add to my manuals12 Pages
Brant Radiant Heaters LR-LB1 Series LED Bay Lighting Fixtures are designed to illuminate industrial locations and can reduce energy use and maintenance needs, improve safety, and reduce CO2 emissions. With a typical mounting height of 8-24 ft. from the ground, these durable fixtures are IP65 certified (Ingress Protection Rating), meaning they are both dust-tight and protected against water projected from a nozzle. This makes them perfect for use in demanding environments. The LR-LB1 Series can dim from 10% to 100%, allowing for adjustable brightness levels to suit specific needs.
advertisement
3.0
Maintenance, Care, and Usage • Bracket Mount Installation
3.0
Maintenance, Care, and Usage
LR-LB1 Series
!
CAUTION
To avoid personal injury, disconnect power to the light and allow the unit to cool down before performing maintenance.
Visual, mechanical, and electrical inspections should be performed on a regular basis. Routine checks at least once a year are recommended. Frequency of use and environmental conditions may make it necessary to perform more than one routine check per year. It is recommended to follow the Electrical Preventative
Maintenance Program as described in NFPA 70B: Recommended Practice of Electrical Equipment.
The lens should be cleaned periodically as needed to ensure continued photo-metric performance. Clean the lens with a damp, non-abrasive, lint-free cloth. If a damp cloth alone is not sufficient, use mild soap or a liquid cleaner. Do not use an abrasive, strong alkaline or acid cleaner as damage may occur.
Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or contamination
(i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.
Electrical connections and wires should be checked for exposed wire and overall circuit integrity.
Bracket Mount Installation
NOTE: Accessory installation sheets supersede these instructions.
1
Sub assemble the eyebolt to the hanging bracket using the two jam nuts and one lock washer
(provided) in a sandwich-like assembly.
2 Use the four screws provided on the main housing to attach the hanging bracket assembly to the housing.
3 Use a chain or cable ( must be able to bare the weight of 50 lbs. or more) and hook into the eyebolt.
Always close “S” hooks if used.
Figure 3.1 • Bracket Mount Dimensions
2.28"
6 ft. 3 Prong
18/3 AWG
Ø11.0"
Rating Plate
3
8
" NPT IP65
Cord Grip
HB Hanging Bracket
5
16
" - 18 Eyebolt
5
16
" - 18 Jam Nut
4.78"
6 7
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project