Inspection. Vermeiren Coraille XXL, Charme Deluxe, Charme, Alesia, Charme Electrical, Altitude XXL, Regina, Altitude, Coraille

Shell chair

2017-01

Only for electrical shell chair:



Disconnect the power cable and carefully roll up the power cable with no kinks and place it in the shell chair.



Check internal cables for squashing and the prevention of kinks.

1.3 Care

1.3.1 Covers

The cleaning of the cover shall be according:

 Clean covers with a cloth moistened with hot water. Be aware that you do not soak the cover.

 Use a mild commercial detergent for removing stubborn dirt.

 Stains can be removed by using a sponge or a soft brush.

 Do not use strong cleaning liquids like solvents, nor use hard brushes.

 Never clean with steam and/or pressure washers.

1.3.2 Plastic parts

Clean plastic parts of your chair with commercial plastic cleaners. Only use a soft brush or soft sponge. Please comply with special product information.

Examples of plastic parts are wheels, protection on the attachment leg support.

1.3.3 Coating

The high quality of the surface layer guarantees optimal protection against corrosion. If the outer coat is damaged by scratching or in some other way, get your specialist dealer to repair the affected surface.

When cleaning, only use warm water and normal household detergents and soft brushes and cloths. Ensure that no wetness gets into the tubes.

Initially the zinc parts only require rubbing with a dry cloth. Stubborn dirt can best be removed by using a suitable commercial zinc polish.

1.3.4 Electronics (only for electrical shell chair)

Before cleaning disconnect the power cable out the power socket.

Clean the electronic parts with a dry cloth.

Do not clean these in an automated washing system or high-pressure cleaner. Do not use any abrasives or sharp-edged polishing equipment like a metal scrubber or brush, since these can scratch the surface of the electronic parts. Do not use fluids that can penetrate in the electronic parts. Do not use a cleaner that contains benzene, alcohol or similar solvents.

1.4 Inspection

In principle we recommend one inspection every year, and a minimum of one before usage is resumed. All of the following checks must be performed and documented by authorized persons:



Check the frame parts for plastic deformation, cracks and impaired functioning.



Visually check for damage to the paintwork (danger of corrosion)



Check the operation of the wheels (free running, level rolling, axle play, wheel immobilizers)



Check the solidity and tightness of all screws, nuts and bolts.



Verify the amount of grease on the metal joints of movable parts



Visually check all plastic parts for cracks and brittle spots

Page 3