Ethernet and Charging Cradles. Zebra ZQ620, ZQ610/620

• Open the protective cover on the printer to expose the DC input charger jack.

• Connect the appropriate AC power cord for your location to the adapter and then plug the power cord into an AC receptacle.

• Plug the barrel plug from the AC adapter into the charger jack on the printer.

• The printer will power up and begin charging. The printer can be left on or turned off at this point. Charging will continue in either state.

Important • While it’s possible to charge the battery when using the printer, charge times will increase under this condition.

Ethernet and Charging Cradles

The cradle is an expansion base intended for use with the ZQ6 printers. There is a four bay cradle (EC4) or a single bay option

(EC) for use with the ZQ610 and ZQ620, as shown on pages

29 and 30. The EC/EC4 cradles provide charging power to the docked printer as well as providing a standard 10/100 Mb/s

Ethernet port for communication to the printer. Both cradles also supply battery charging power to the docked printer and act as a supplementary power source.

They feature two LED’s to indicate the status of the cradle: Solid green to indicate when power is provided to the input of the cradle; and blinking green to indicate Ethernet activity. The cradles allow the user to dock the printer easily and remove it with the push of a button. The printer will remain operable while docked, i.e. display is viewable, charge LED status is viewable, and printer controls and data entry are available. The printer will still print while docked and the user will be able to replace the media as well.

25

ZQ610 & ZQ620 User Guide