Select Install CDR/DVDR Software onto your PC and the software will be automatically installed. You can choose to OPEN from location or SAVETO, depending on your hardware configuration. If you choose SAVETO, save to your DESKTOP so you can later delete the setup file.
Once the software is installed, it will require a restart. Go ahead and let the PC shutdown (POWER OFF) completely and continue to the next section.
Step 3B
Installation and Connection of AC Power, Firewire®, and Serial Link
While the PC is off:
Plug the serial cable into the PC and into the back of the Elite unit.
Plug the Firewire cable into the PCI IEEE 1394 card that was previously installed into the PC and into the back of the Elite unit.
Plug the power cord into the power supply of the Elite, also located on the rear of the unit. Plug into a standard 115VAC outlet.
We recommend that you plug these components into a common power strip with surge protectoin and AC filtering. We also strongly recommend that you use a UPS to protect your system in the event of power outages.
T
www.discmakers.com 1-888-800-4041 10