Clearances. Empire Comfort Systems DVP42FP731P-1, DVP36FP31N-1, DVP48FP9(1,3)(N,P)-1, DVP36FP73P-1, P)-1, DVP48FP730N-1, DVP42FP9(1,3)(N,P)-1, DVP36FP72P-2, DVP42FP933P-1, DVP48FP931N-1
Add to my manuals
56 Pages
advertisement
Clearance to Combustibles
Back
Side
Floor
Top Stand-off
0" (0 mm)
0" (0 mm)
0" (0 mm)
0" (0 mm)
Top Framing Edge 3" (76 mm)
SEE MANTLE CHART FOR
MAXIMUM MANTLE DEPTH
SEE MANTLE CHART
FOR MINIMUM HEIGHT
OF MANTLE ABOVE UNIT
2" x 4" HEADER
STAND OFF
3" (76 mm) HEIGHT
ABOVE TOP OF
FIREPLACE
CLEARANCES
Mantel Chart (Figure 3)
12” (305mm)
10” (254mm)
MANTEL
8”
15”
(381mm)
6”
13 3/4”
4 ½”
3 3/4”
3”
11”
9”
8”
7”
6”
5”
4”
3”
TOP EDGE OF FIREPLACE
FINISHED WALL
(COMBUSTIBLE)
NON-COMBUSTIBLE
FIRST 3 (SEE MAGNIFIED
VIEW)
”
NAILING
FLANGES
3"
COMBUSTIBLE TRIM AND MANTELS
ALLOWED IN SHADED AREA
2 1/4”
1 ½”
3/4”
Figure 3
Clearances (Figure 4)
Clearance from top front edge of fireplace to ceiling is 36"
Clearance from side of fireplace to adjacent sidewall is 6".
TOP FRAMING
LEDGE
GLASS FRONT
(914mm)
Figure 2
Combustible Material
No greeting cards, stockings or ornamentation of any type should be placed on or attached to the fireplace. The flow of heat can ignite combustibles.
LOCATING FIREPLACE
Figure 4
Note: Island (C) and Room Divider
(D) installation is possible as long as the horizontal portion of the vent system (H) does not exceed
20 feet with a minimum vertical run of 8 feet. See details in Venting
Section.
When you install your Direct Vent
Fireplace in (D) Room divider or
(E) Flat on wall corner positions, a minimum of 6 inches clearance must be maintained from the perpendicular wall and the front edge of the appliance.
Page 8
CORNER
INSTALLATION
ANGLED CORNER
INSTALLATION
ISLAND
INSTALLATION
CABINET
INSTALLATION
ROOM DIVIDER
INSTALLATION
FLUSH WALL
INSTALLATION
Figure 5
17375-10-0706
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 Important Safety Information
- 4 Safety Information for Users of LP Gas
- 5 Requirements for Massachusetts
- 6 Introduction
- 7 Specifications
- 7 Fireplace Dimensions
- 8 Clearances
- 8 Locating Fireplace
- 9 Gas Supply
- 10 Rear Vent Conversion/Vent Systems
- 11 Installation
- 15 Venting Fireplace-Top Vent
- 19 Venting Fireplace-Rear Vent
- 21 Termination Clearances
- 22 Vent Clearances
- 23 Vent System Identification
- 24 Framing and Finishing
- 25 Horizontal Termination
- 26 DVVK-5F Flex Vent
- 27 Vertical Termination
- 29 Log Placement
- 30 Operating Instructions
- 32 Wiring Diagram-Standing Pilot
- 33 Lighting Instructions-Standing Pilot
- 34 Troubleshooting-Standing Pilot
- 35 Intermittent Pilot Operating Instructions
- 35 Intermittent Pilot Wiring Instructions
- 36 Intermittent Pilot Lighting Instruction
- 37 Intermittent Pilot Troubleshooting
- 41 RF Standing Pilot Operating Instructions
- 42 RF Transmitter Functions
- 43 RF Wiring Diagram
- 44 RF Standing Pilot Lighting Instructions
- 45 Maintenance and Service
- 46 Parts View
- 47 Parts List
- 49 FBB4 Optional Variable Speed Blower Installation
- 51 Junction Box Wiring Installation Instruction
- 51 Optional Brick Liner Installation Instruction
- 52 Accessories
- 53 How To Order Repair Parts
- 53 Service Notes