advertisement
Connections
OOFER
Option 3 Option 4
ANT IN
RF coaxial cable to TV
2
INT IN
Back of RF Modulator
(example only)
TO TV
VIDEO
IN
AUDIO IN
R L
CH3 CH4
Antenna or
Cable TV signal
3
1
REAR
LEFT
SUBWOOFER
2
1 3
4
IMPORTANT!
If S-Video is used for DVD playback, the system’s VIDEO OUT setting will need to be changed accordingly.
Details are on page 25.
Using S-Video jack
1
Use an S-video cable (not supplied) to connect the DVD system’s
S-VIDEO
OUT jack to the S-Video input jack
(or labeled as Y / C or S-VHS) on the TV.
2
To hear the TV channels through this
DVD system, use the supplied audio cables (white / red) to connect
AUDIO
IN-TV) jacks to the corresponding
AUDIO OUT jacks on the TV.
3
Set the
P-SCAN switch to ‘OFF.’
IMPORTANT!
If your TV only has a single Antenna In jack (labeled as 75 ohm or RF In,) you will need an RF modulator in order to view DVD playback on the TV. See your electronics retailer or contact
Magnavox for details on RF modulator availability and operations.
Using an accessory RF modulator
1
Use the supplied composite video cable
(yellow) to connect the DVD system’s
VIDEO OUT jack to the video input jack on the RF modulator.
2
Use an RF coaxial cable (not supplied) to connect ANTENNA OUT or TO TV jack on the RF modulator to the ANTENNA
IN jack on the TV.
3
Connect the Antenna or Cable TV service signal to the ANTENNA IN or
RF IN jack on the RF modulator. (It may have been connected to your TV previously. Disconnect it from the TV.)
4
Set the P-SCAN switch to ‘OFF.’
11
001-037-MRD120-37-Eng 11
advertisement
Related manuals
advertisement