advertisement
Problem solving guide
Water inlet fault
Problem
The In-operation indica‐ tor is flashing quickly.
The buzzer is sounding.
One of the following faults is shown in the display:
Open stopcock
Water intake
The following message appears in the display during the gramme:
SolarSave
Intake temp. low
pro‐
Cause and remedy
The stopcock is closed.
Open the stopcock fully.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water intake is restricted.
Open the stopcock fully and start the programme again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than 30 kPa (0.3 bar).
Seek professional advice.
The intake water has not reached the required tem‐ perature of 45°C (see "Plumbing, Connection to the water supply").
Start the programme again.
If the fault message appears again, select a differ‐ ent programme.
69
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Key Features
- Full size (60 cm) Fully built-in
- 14 place settings 9.7 L 41 dB
- Auto, Glass/Delicate, Eco, Intensive, Normal, Quick, Silent
- 24 h Delayed start timer