Maintenance. Miele G 6572 SCVi

Maintenance

Cleaning the water inlet filter

A filter is incorporated in the screw con‐ nection of the valve on the water inlet hose. The filter must be cleaned when dirty, otherwise insufficient water flows into the wash cabinet.



The plastic housing of the water connection contains an electrical component.

The housing must not be dipped in water.

Recommendation

If the mains water contains a large number of insoluble substances, we recommend fitting a large-area filter in the connection between the stopcock and the water inlet hose threaded un‐ ion.

This filter is available from Miele.

Cleaning the filter:

 Disconnect the dishwasher from the mains supply.

Switch off at the mains socket and withdraw the plug.

 Close the stopcock.

 Unscrew the inlet hose.

 Carefully remove the seal.

 Withdraw the filter using pointed pli‐ ers and rinse clean under running water.

 Replace the filter and seal, making sure they are sitting correctly.

 Reconnect the inlet hose to the stop‐ cock, making sure it goes on correct‐ ly and is not cross-threaded.

 Open the stopcock.

If water leaks out, the inlet hose may not be connected securely or it may have been screwed on at an angle.

 Unscrew and reconnect the water in‐ let valve correctly.

76