DMS Go Operator&#39

Appendix B. DR File Type Explanations

B.5.1 Boiler File Flexibility

•

Free choice of first tube to be tested

.

•

Free choice of distance with “skipping” of tubes

Note: If you are measuring ribbed tubes and recording in a Boiler file, you can automatically insert “OBST” into a designated series of C

(center) positions. Set up the file with the “Points on Tube” option set to “L, C, R” (left, center, right). At a specific center (c) data

location, press F3 (OBST). A screen appears similar to Figure 38 below.Enter the end tube number for the last center location to

contain OBST. The DMS Go then inserts OBST into the designated center locations The user may then attach a “RIBBED” comment to all obstructed positions

Figure 38: OBST Setup Option

146 DMS Go Operator’s Manual