Omron C200H CPU0, CPU2, CS1G CPU42H Programmable Controller Replacement Guide

Below you will find brief information for Programmable Controller C200H CPU0, Programmable Controller C200H CPU2, Programmable Controller CS1G CPU42H. This document provides reference information for replacing C200H PLC systems with CS1 series PLC. This guide describes the procedure to rebuild the system which uses the C200H-series PLC by introducing the CS1-series PLC.

PDF
Document
Programmable Controller C200H CPU0, C200H CPU2, CS1G CPU42H Replacement Guide | Manualzz

Advertisement

Advertisement

/

Advertisement

Key features

  • Replacement of C200H PLC systems with CS1 series PLC

  • System rebuilding with CS1-series PLC

  • Procedure for replacing C200H-series PLC

  • Upgrade and maintenance of legacy systems

Frequently asked questions

This document provides reference information for replacing C200H PLC systems with CS1 series PLC.

The document describes the procedure to rebuild the system which uses the C200H-series PLC by introducing the CS1-series PLC.

Yes, using the C200H I/O Terminal Block Conversion Adapter allows you to reuse the terminal blocks for the CS1-series Basic I/O Units.

The I/O allocation of C200H-series is partly different from that of CS1-series. For example, C200H-series uses "Free location and fixed channel" for Basic I/O while CS1-series uses "Free location and free channel". You need to change the channel and bit address used in the program accordingly.

You can convert the program using the CX-Programmer. The instructions are mostly automatically converted, but some require manual modification. Refer to Appendix A in the document for details on instructions that need to be changed manually.

Some PLC settings are different between the two series. For example, the Mode at Power ON and Constant Cycle Time are set differently. Refer to Appendix C for details.

The execution method and timing of interrupts differ between the two series. C200H uses subroutines for interrupt programs, while CS1 uses interrupt tasks. Additionally, the cycle time is shortened with CS1. You need to check the operation with the converted program if the system operation is affected by the cycle time.

Preparing document for printing…
0%