Psion Teklogix WorkAbout Pro C Handheld computer Quick Start Guide

4
Charge the battery. The power adaptor may
be plugged directly into the WORKABOUT PRO.
5
Turn the unit on. Press the Enter key
for a few seconds.
Orange FN key
Blue FN key
Enter key
To turn the WORKABOUT PRO off, do one
of the following:
· Press and release the Blue FN key, then press and release the
Enter key.
· Select Shut down from the Start menu.
Quick Start Guide
Resetting the unit
Important: Resetting may result in data loss.
To cold-reset the WORKABOUT PRO:
The WORKABOUT PRO may also be charged
in a Docking Station.
Note: Use only the
universal AC power
adaptor approved by
Psion Teklogix for the
WORKABOUT PRO.
Allow the WORKABOUT PRO to charge
for 6 hours.
5 - 40 °C
41 - 104 °F
Note: Full battery performance is
only reached after the first few full
charge/discharge cycles.
6h
6
Connect the WORKABOUT PRO to the
host computer. Connect using a Tether Port to
USB cable, or through a Docking Station.
7
8
Install ActiveSync®.
Download ActiveSync® 4.5 or higher from
http://www.microsoft.com and follow the
instructions to install it onto the host computer.
Note: ActiveSync is not needed when connecting to
a host that is using Microsoft® Vista®.
Configure ActiveSync.
Follow the onscreen instructions provided by
ActiveSync to establish a connection between
the host computer and the WORKABOUT PRO
in the Docking Station.
Hand-Held Computer
C Version
June 6, 2007
· Press the Blue FN key, the Orange FN key, and the Enter
key simultaneously for a few seconds. The WORKABOUT
PRO cold-resets.
During a cold reset, running programs are halted and RAM
memory is cleared. The contents of flash memory and the
registry are preserved. The operating system is reloaded.
To warm-reset the WORKABOUT PRO:
· Press the Blue FN key and the Enter key simultaneously for a
few seconds. The WORKABOUT PRO warm-resets.
During a warm reset, running programs are halted. The contents
of RAM, flash memory and the registry are preserved.
*8100129-001*
8100129-001
Rev. A
ISO 9001 Certified
Quality Management System
PN: 8100129-001.A
Contents of the box:
Getting Started
Switch the hardware on.
Features: The Battery Compartment
Features: Back and Ports
1
Battery cover
Card gate (closed)
Back cover
d Com
C Version puter
PN: 81001
29-001
Additional documentation
(dependent on order)
.A
On/Off switch
Tether port
ISO 9001
Certified
Quality Manage
ment System
The WORKABOUT PRO
Beeper port
This Guide
ON
FCC labels
Hand-Hel
Quick Sta
rt Guide
June 6,
2007
Endcap
LIF port
DC input
Stylus
SIM Card slot
SD Card slot
Features: Typical Variants
2
Insert the battery.
3
Close and lock
the battery cover.
Features: Front
Speaker
Stylus
Microphone port
Scan bar
LED
indicator
On/Off switch
Card gate (open)
Version without
scanner or
GSM radio
Version with GSM
radio and scanner
in endcap
Version with scanner
in endcap
Battery fasteners
Battery cover
Version with scanner
in pod
Version with pistol grip
Note: The SIM Card slot
may be covered on your unit.
Turn the latches towards
the centre of the unit
to lock the battery cover.
Over
">