RY141600 QUICK REFERENCE GUIDE
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product. All page references refer to the operator’s manual.
FIRST TIME ASSEMBLY STARTING THE UNIT USING DETERGENT
1 Connect the spray wand to the trigger handle
(see page 10).
3 Connect the high pressure hose to the pump (see page 10).
1 Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
ready for operation (see page 11).
1
Pour pressure washer
detergent in soap tank (see page 13).
2
Install blue or black soap
nozzle (see page 13).
3
Squeeze trigger and wait
approx. 5 seconds for soap
(see page 13).
25
DETERGENT
5 S
2
Connect the high pressure hose to the trigger
handle (see page 10).
4
Connect the garden hose to the pump (see page
10).
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger to relieve air pressure. Hold the trigger until a steady stream of water appears.
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 3 and 8).
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
Cord Length
25 ft.
50 ft.
100 ft.
NOTE: A.W.G. = American Wire Gauge
Wire Size (A.W.G.)
14
12
Not Allowed
Use of soap nozzle will activate detergent injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
NOZZLE SELECTION GUIDE
Use the chart below to determine the correct nozzle for your job.
HIGH PRESSURE
(NO SOAP WHEN USING
THESE NOZZLES)
LOW
PRESSURE
(FOR SOAP OR
GENTLE RINSE)
2 Press switch ON to start the motor (see page 11).
SWITCH
ON
3 When finished, press switch OFF to stop the motor (see page 12).
SWITCH
OFF
Turbo Nozzle 15º
Blue or Black
Soap Nozzle
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
Recommended Nozzle
Use With Caution for Certain Applications
BEFORE STORING THE UNIT
1 Always add Pump Protector to the unit after each use and before storing. This will significantly im-
prove pump life. (See page 14.)
Pump protector is available from your local retailer. For further assistance, call customer service at
1-800-860-4050.
To add, follow the instructions provided by the Pump Protector manufacturer.
PUMP
PROTECTOR
Make the most of your purchase! Go to www.ryobitools.com and register your new tool online. For questions about operating or maintaining your product please call, 1-800-860-4050.
991000343
12-22-14 (REV:01)
