TH-2250-VF
Installation Instructions
TM
Flat Screen Wall Mount | Fixed
Important Notes
The Telehook 2250 Wall Mount supports Flat Panel Displays from 20” (50cm) to 37” (94cm)
and supports a maximum load of 50kgs (110lbs).
This product only supports VESA compliant displays with 100mm x 100mm (4”x4”), 100mm x 200mm (4”x8”)
and 200mm x 200mm (8”x8”) mounting hole patterns.
The manufacturer does not accept responsibility for incorrect installation.
Component Checklist
Bits Bag
Wall Plate
Coach
Screw (x4)
Large
Washer (x4)
Mounting Screws
M6x12mm & M6x20mm
Phillips Head Screw
(x6 each)
TOOLS REQUIRED:
Power Drill
10mm or 6mm Drill Bit
Phillips Head Screw Driver
Spirit Level
Socket Wrench or Shifter
Masonry Wall
Plug (x4)
Dry Wall
Anchor (x4)
M5x12mm & M5x20mm
Phillips Head Screw
(x6 each)
Display Plate
A Mounting the Wall Plate
Masonry Wall
Note: Ensure the Wall Plate is mounted with the arrow cut out pointing upwards.
10mm ( 3
Hole
/
8
”)
Masonry
Wall Plug
Spacer
Bush (x6)
Timber Stud Wall
Note: Ensure the Wall
Plate is mounted with the arrow cut out pointing upwards.
M4x12mm & M4x20mm
Phillips Head Screw
(x6 each)
Timber
Stud
6mm ( 1
Hole
/
4
”)
Dry Wall
Note: Ensure the Wall Plate is mounted with the arrow cut out pointing upwards.
10mm ( 3
Hole
/
8
”)
Dry Wall
Anchor
Wall Plate
Coach Screw
Washer
TIP: Use a spirit level to ensure the wall plate is horizontal
Wall
Plate Washer
Coach Screw
TIP: Use a spirit level to ensure the wall plate is horizontal
Use a stud finder to accurately locate the centre of the stud.
Ensure that all four screws fix securely into the stud
Wall Plate
Dry Wall
Anchor Screw
Dry Wall
Anchor Washer
TIP: Use a spirit level to ensure the wall plate is horizontal
B Mounting the Display Plate
Note: When attaching the Display Plate to the back of the display, ensure that the arrow cut out in the Display Plate is pointing towards the top of the display
Mounting Screw
(12mm ( 1 /
2
”) Length)
Back of Display
Mounting Screw
(20mm ( 13 /
16
”) Length)
Back of Display
Spacer Bush
Recessed
Mounting Hole
Display
Plate
Recessed Mounting Holes
If the mounting holes are recessed into the back of the display, use the supplied Spacer Bushes to pack the recessed holes. Ensure that the correct 20mm length mounting screws are used to securely fix the plate to the display.
Display
Plate
Top of
Display
C Attaching the Display to the Wall Plate
With the Display
Plate attached to the display, lift the display and hook the plate through the four corresponding mounting holes in the Wall Plate as shown.
Mounting
Hole
Hook
Note: For demonstration purposes, the wall has been omitted from the above image.
Mounting
Hole
Hook
D Security Option
Locking
Tabs
M4 Mouning
Screw
To properly secure the display to the wall it is recommended to use two of the supplied M4 mounting screws to securely attach the two plates together.
Note: For demonstration purposes, the wall has been omitted from the above image.
Due to continuing product development, the manufacturer reserves the right to alter specificationswithout notice. Published: 06.05.09 ©
