TH-3060-UF
Installation Instructions
Flat screen wall mount | fixed
Component Checklist
Hardware
M4x10/20mm (x4 each)
Coach Screw (x6)
Wall Plate
Left Mounting
Bracket
Right Mounting
Bracket
Tools Required:
•
•
•
•
•
Power Drill
3mm (1/8”) drill bit
Phillips Head screwdriver
10mm (3/8”) masonry drill bit
11mm (7/16”) Socket Wrench or Shifter
M5x10/20mm (x4 each)
Multi-washer (x4)
M6x10/20mm (x4 each)
M6 Washer (x6)
M5/M6 Spacer (x4)
M8x15/30mm (x4 each)
M8 Spacer (x4)
Nylon Anchor (x6)
Display Mounting
Screws
IMPORTANT INFORMATION
!
!
!
!
!
IMPORTANT - Install Telehook 3060 Wall Mount as per Installation Instructions.
This product supports a maximum load of 50kg (110lbs).
This product only supports displays with mounting hole configurations from 100mm wide x 100mm
high up to 600mm wide x 400mm high.
The manufacturer does not accept responsibility for incorrect installation.
Before installing this Telehook product, please check the display ventilation requirements with your
LED/LCD manufacturer.
Step 1. Check Components
Check you have received all parts against the Component Checklist and Hardware above.
Step 2. Mounting the Wall Plate
Masonry Wall
Timber Stud
Note: Use a stud finder to accurately locate the centre of
the stud. Ensure that all screws fix securely into the stud.
Nylon Anchor
10mm (3/8”) hole
depth: 60mm (2.5”)
Timber Stud
3mm (1/8”) hole
depth: 40mm (1.5”)
Wall Plate
OR
Wall Plate
Coach Screw
Coach Screw
M6 Washer
M6 Washer
Tip: Use the built-in spirit level to ensure wall plate is horizontal
Step 3. Attaching Brackets to Display
Right Mounting
Bracket
Mounting Screw TOP
Multi-washer
Spacer
(optional, use only for
recessed mounting holes)
Left Mounting
Bracket
Step 4. Attaching/Detaching Display to Wall Plate
Lift your Display, hooking the Mounting
Brackets over the top of the Wall Plate Rail.
Pull down on the two Straps, and gently push
the bottom of the Display towards the Wall.
Release the Straps to engage the locking
mechanism, safely securing the Brackets to
the Wall Plate.
(2 people required)
WALL
WALL
HOOK
Note: Make sure the TV is correctly hooked before
releasing the Display.
Detaching Display from Wall Plate:
Pull down on both Straps to disengage the
locking mechanism. At the same time lift
the Display away from the Wall Plate.
SECURE
PULL
Straps
RELEASE
Step 5. Hide Straps
If necessary, shorten
the length of the Straps
using the hook-and-loop
fastener strip, so that
they cannot be seen.
Installation Complete
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 07/12/2010 ©
">
