TH-3060-UF
Installation Instructions
Flat screen wall mount | fixed
Component Checklist
Hardware
M5x14mm (x4 )
Coach Screw (x4) Multi-washer (x4)
Wall Plate Left Mounting
Bracket
Right Mounting
Bracket
•
•
Tools Required:
•
•
•
Power Drill
5mm ( 0.2 ”) drill bit
Phillips Head screwdriver
10mm (
10mm (
0.39
0.39
”) masonry drill bit
”) Socket Wrench or Shifter
M6 Washer (x4) M5/M6 Spacer (x4)
M6x14/30mm (x4 each)
Nylon Anchor (x4)
M8x 20/30mm (x4 each)
Display Mounting
Screws
M8 Spacer (x4)
IMPORTANT INFORMATION
! IMPORTANT - Install Telehook 3060 Wall Mount as per Installation Instructions.
! This product supports a maximum load of 50kg (110lbs).
! This product only supports displays with mounting hole configurations from 100mm wide x 100mm
high up to 600mm wide x 400mm high.
! The manufacturer does not accept responsibility for incorrect installation.
! Before installing this Telehook product, please check the display ventilation requirements with your
LED/LCD manufacturer.
Step 1. Check Components
Check you have received all parts against the Component Checklist and Hardware above.
Step 2. Mounting the Wall Plate
Masonry Wall
Nylon Anchor
Timber Stud
Note: Use a stud finder to accurately locate the centre of the stud. Ensure that all screws fix securely into the stud.
10mm ( 0.39 ”) hole depth: 55mm (2.2”)
Timber Stud
5mm ( 0.2 ”) hole depth: 55mm (2.2”)
OR
Wall Plate
Coach Screw
Wall Plate
Coach Screw
M6 Washer M6 Washer
Tip: Use the built-in spirit level to ensure wall plate is horizontal
Step 3. Attaching Brackets to Display
Right Mounting
Bracket
Mounting Screw
Multi-washer
TOP
Spacer
(optional, use only for recessed mounting holes)
Left Mounting
Bracket
Step 4. Attaching/Detaching Display to Wall Plate
Lift your Display, hooking the Mounting
Brackets over the top of the Wall Plate Rail.
Pull down on the two Straps, and gently push the bottom of the Display towards the Wall.
Release the Straps to engage the locking mechanism, safely securing the Brackets to the Wall Plate.
WALL
HOOK
Note: Make sure the TV is correctly hooked before releasing the Display.
Detaching Display from Wall Plate:
Pull down on both Straps to disengage the locking mechanism. At the same time lift the Display away from the Wall Plate.
PULL
Straps
Step 5. Hide Straps
If necessary, shorten the length of the Straps using the hook-and-loop fastener strip, so that they cannot be seen.
(2 people required)
WALL
RELEASE
SECURE
Installation Complete
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 30/10/2012 ©
