Peavey Scorpion Ultra 12 User's Manual

 The Peavey Scorpion® Ultra 12”
loudspeaker was designed for high level
guitar applications. The large diameter
edgewound aluminum voice coil will ensure
high power handling and reliable operation in
the most demanding situation. The large
spoke diecast aluminum frame and field
replaceable cone assembly are features found
only in premium transducers.
The Scorpion Ultra 12", 8 ohm speaker
contains a 2.5 inch voice coil incorporating
the largest magnet structure ever in a
Scorpion Series speaker. The sound
characteristics have been emphasized on lead
guitar for those full and rich lead voicings
typical of contemporary music.
The Scorpion Ultra 12”
SPECIFICATIONS
Diameter - 12 inches
Nominal Impedance - 8 ohms
Power Handling Capacity -
Continous 1150 Watts
Program” 300 Watts
Sensitivity 103 dB (8 ohms)
Voice Coil Diameter 2.5 inches
Depth 5% inches
Net Weight 18 Lbs.
“This specification requires a minimum of 3dB of amplifier headroom.
BASKET ASSEMBLY REPLACEMENT
Prior to replacement
procedure, clean work area of
all metal objects and other
debris.
With the speaker lying face
down, remove the three screws
on the back of the magnet
structure.
When the three screws are
removed, carefully lift the
magnet structure vertically
from the basket assembly and
flip structure over with the gap
up.
EJ
Place the magnet structure
on a flat surface with the “gap”
| facing upward and carefuly
lower the new basket assembly
onto the magnet structure. Use
extreme care in order to avoid
damaging the voice coil.
CU
Lo
e жен
Clean the voice coil “gap” to
remove any foreign matter.
Foldastrip of masking tape into
a small triangle with the
adhesive side out for this
procedure.
Firmly grasp both the basket
assembly and the magnet
structure with both hands and
carefully turn the entire
assembly over on its face.
With the speaker face down,
replace the three screws and
tighten.
PEAVEY TRANSDUCER WARRANTY
Peavey Transducers are warranted to the original purchaser to be free from defects in workmanship and materials for one year
after initial purchase date. This warranty is contingent upon proper use of the transducer and does not warrant suitability for any
single application or location. Transducers that have been abused in any fashion, modified or tampered with, are not covered
under this warranty. Warranty status shall be determined by Peavey Electronics Corp. upon inspection of inoperative unit at the
factory.
Transducers that are returned for warranty service must be sent prepaid to the factory for inspection and/or service. A copy of
the sales receipt on the original purchase of the transducer, along with a description of the problem, must be enclosed with the
returned unit. Please be sure to include your return address.
This warranty applies only to those transducers manufactured by Peavey Electronics Corporation.
Due to our efforts for constant improvement, features and specifications are subject to change without notice.
PEAVEY ELECTRONICS CORPORATION
711 A Street/Meridian, MS 39301/U.S.A.
Telephone: (601) 483-5365/Telex: 504115
©1087 Printed in the U.S.A.
#80300725 2/87