P E A V E Y E L E C T R O N I C S

15” Scorpion

®

Replacement

Basket

The Peavey Scorpion ® Plus ™ 15” loudspeaker was designed to high level professional requirements, which is sound reinforcement, public address, and low frequency musical instrument applications.

Impregnated with Kevlar ® to maintain an extremely rigid platform that can provide enhanced linearity at high drive levels. At any drive level, Kevlar gives the added benefit of greater mechanical damping, resulting in higher fidelity through lower distortion.

The Scorpion Plus unique suspension design further contributes to the high reliability in very low distortion by allowing very long excursions with associated low distortion. The large spoke die cast, aluminum frame, and field replaceable cone assembly are features usually found in ultra premium transducers such as the

Peavey Black Widow ® Series.

The Scorpion Plus 15” Kevlar ® impregnated cone loudspeaker is another example of the versatility and reliability sound in all Peavey products.

SPECIFICATIONS

Diameter – 15”

Nominal Impedance – 8 ohms / 4 ohms

Power Handling Capacity –

Continuous 200 watts

Program* 400 watts

Sensitivity – 101 dB (8 ohms) / 100 dB (4 ohms)

Voice Coil Diameter – 2.5 inches

Flux Density – 13000 Gauss

Depth – 5 7/8 inches

Net Weight – 12 ¾ lbs.

THIELE/SMALL PARAMETERS

Znom

Fs

RE

QTS

VAS

VD

8 Ohms

50.2 Hz

5.54Ω

0.326

132.4L

22.1 in3 (362 ml)

Efficiency (half space) 4.70%

SD (diaphragm area) 0.0731M

2

4 Ohms

49.4 Hz

3.35Ω

0.415

138.9L

22.1 in3 (362 ml)

3.62%

0.0731M

2

*This specification requires a minimum of 2 dB of amplifier headroom.

Kevlar ® is a registered trademark of DuPont Company

Scorpion

®

Basket

Assembly

Replacement

Replaceable baskets eliminate the need for re-coning speakers and the frustration and delays associated with the re-coning process. It only takes a few minutes to replace a basket and you are back in business.

It just can’t get any easier than the four steps outlined here.

1

3

2

4

Baskets are replaced in four easy steps:

1 Remove three screws on back of magnet structure.

2 Lift the magnet structure off the basket frame.

3 Clean the voice coil “gap”.

4 Align screw holes, lower structure into place on new

basket frame, insert screws and tighten.

ONE YEAR LIMITED WARRANTY

NOTE: For details, refer to the warranty statement. Copies of this statement may be obtained online at www.peavey.com.

Features and specifications subject to change without notice.

Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305

(601) 483-5365 • FAX (601) 486-1278 • www.peavey.com

©2011 Printed in the U.S.A. 1/11 80300072

Logo referenced in Directive 2002/96/EC Annex IV

(OJ(L)37/38,13.02.03 and defined in EN 50419: 2005

The bar is the symbol for marking of new waste and is applied only to equipment manufactured after

13 August 2005