Panasonic CQC5300W Operating Instructions

E
N
G
L
I
S
H
E
N
G
L
I
S
H
General
[MUTE] (Mute/attenuation) [VOLUME]
(SBC-SW)
indicator
[DISP] (Display)
1
Source
Volume
Press [SOURCE] to change the source.
CQ-C5400W
2
[VOL "]: Up
[VOL #]: Down
CQ-C5300W
Radio (page 28)
Up
Down
Setting range: 0 to 40
(default: 13)
CD player (page 31)
[SOURCE]
(PWR: power)
Level meter
(This varies the display
in line with the volume level.)
Spectrum analyzer
(This shows two sets of levels for each of the following frequencies
in sequence starting from the left: 60 Hz, 160 Hz, 400 Hz, 1 kHz,
3 kHz, 6 kHz, 16 kHz.)
or
MP3/WMA player (page 32)
When a MP3/WMA data disc
is in the player.
Point the remote control unit at the remote control signal sensor.
Power
Mute/Attenuation
Turn your car’s ignition key
to the ACC or ON position.
ON:
CD changer control (page 36)
ACC
ON
Press [SOURCE] (PWR).
Demonstration:
When the power is switched on for the first time,
a demonstration appears on the display.
Press [DISP] (display) to change to regular
mode.
When an optional CD changer
is connected.
Press [SOURCE] (PWR) again and hold
until you hear a beep (about 1 second),
then release it.
CQ-C5400W CQ-C5300W
Press [SOURCE] (POWER) again and
hold for more than 1 seconds.
CQ-C5100W
Press [PWR] again.
Scrolling
Note:
≥ To display the demonstration again, press and
hold [SOURCE] for more than 4 seconds when
turning power on.
ON:
OFF:
Press [MUTE]. (
lights.)
Press [MUTE] again.
You can select mute or attenuation (page 42).
AUX (page 59)
No sounds. (default)
Decrease the volume by 10 steps.
CQ-C5100W
OFF:
Note:
≥ The volume level can be set independently for
each source (for radio, one volume setting for
AM, one volume setting for all FMs).
Radio (page 28)
Rear Speakers as Sub-Woofers
(Super Bass Control Subwoofer/SBC-SW)
CD player (page 31)
You can utilize the rear speaker connected to the
built-in amplifier as Sub-Woofers that output only
bass. (default: OFF)
CD changer control (page 36)
When an optional CD changer
is connected.
Press and hold [MUTE] (SBC-SW) for more than
2 seconds.
OFF
(default)
Note:
≥ After turning off the ignition key, a security
message is displayed, and the panel removable
alarm that reminds you to take the panel is
activated.
(When security function is set on to on, page 42)
24
CQ-C5400/5300/5100W
ON
(
lights.)
Note:
≥ When ON has been selected, the settings resulting
from the adjustments performed at the subwoofer
level and subwoofer low pass filter settings are
reflected in the output.
≥ Depending on the speakers used and the type of
music played, it may not be possible to achieve a
satisfactory effect.
CQ-C5400/5300/5100W
25
E
N
G
L
I
S
H
E
N
G
L
I
S
H
General (continued)
[SQ] (Sound Quality)
[MENU] (DIM)
[<: eject]
(OPEN/TILT)
indicator
3
SQ (Sound Quality)
Dimmer
SQ is a function that can call up various sound
types at the touch of button in accordance with your
listening music type.
At SQ7, SQ presets P2 to P6 can also be finely
adjusted to suit the acoustic characteristics inside
the car and the user’s preference (page 38).
Press [SQ] to select a sound types
as follows.
SQ preset buttons [1] to [6]
[DISP] (Display)
4
Press and hold [MENU] (DIM) for more than
2 seconds to change dimmer level setting as
follows.
Brighter (default)
Medium
Darker
lights (except SQ-FLAT).
Preset number
Open the Front Panel
Press [<: eject] (OPEN).
Note:
≥ If nothing is changed for 20 seconds, the original
panel position will be recovered.
Close the Front Panel
Press [<: eject] (OPEN) again.
Flat frequency response
not emphasize. (default)
Caution:
≥ Do not pinch your finger or hand in the front
panel when the panel is in motion.
Panel Angle (Tilt)
Press and hold [<: eject] (TILT) until you hear a
beep (about 1 second) from the speaker output, and
“TILT” is displayed. And then release it.
Set it to the position at which it is easy to read what
is on the display.
Each time the above operation is repeated, the panel
angle changes in the sequence shown below.
(default)
TILT 1 TILT OFF
TILT 2
TILT 3
Open
Sharp and dynamic
sound. Powerful deep
bass and turgescent
treble.
Prevention of excessive
equalizing and capability
to cover wide variety of
music. Listener-friendly
and crisp sound.
Highlighted vocals
that are apt to be
overwhelmed by
instrumental sound.
Sound with emphasis on
sharpness of high-hat
and echo of saxophone.
Jazz-specific deep
sound.
Reproduction of realism
being in a club.
Press [DISP] (display) to return to the regular
mode.
≥ If [<: eject] (OPEN) is pressed when a disc is in
the player, the front panel opens and the disc is
ejected automatically.
If no operation takes place for 20 seconds, the
disc is automatically retracted into the main unit.
26
CQ-C5400/5300/5100W
Note:
≥ The position which has been set using TILT will
be retained even when the operations below are
performed.
• OPEN/CLOSE
• Power on/off
Note:
≥ If no operation takes place for more than
5 seconds, the display returns to the regular mode.
≥ After pressing [SQ] on the main unit, you can
also select a sound type by pressing the preset
buttons [1] to [6].
≥ Setting of SQ, bass/treble and volume are
influenced one another. If the influence mentioned
above causes distortion to the audio signal,
readjust bass/treble or volume (page 38).
CQ-C5400/5300/5100W
27