Summit DW18 refrigerator Instructions

Below you will find brief information for refrigerator DW18. The DW18 refrigerator has a stainless steel panel pre-installed on the door. You can install your own custom panel if you need to. The document provides instructions on how to safely remove the existing panel. By following the steps outlined in the document, you can detach the panel, remove the ground wire, and install a custom panel.

PDF

Document

DW18 PANEL INSTRUCTIONS
This unit ships with a stainless steel panel pre-installed on the door. If you are planning to
install your own custom panel, you must first follow the instructions below to safely remove the
existing panel.
1. Open the door with the stainless steel panel still attached.
2. Place a box or some other form of support under the door, as the panel will be detached and may fall to
the floor upon release.
3. Remove the (10) screws labeled in the top view of the door below as A, B, &amp; C
A = long screws
B = short screws
C = medium screws
NOTE: Do NOT remove the screws that hold the lock in place at the top of the door
4. Detach the panel mounting bracket from the door and allow the door to close.
5. Detach the ground wire from the point labeled “D” in the diagram below:
6. Detach the panel from the bracket by removing the (4) screws labeled “E”
7. In order to attach your custom panel, refer to Page 16 of the Installation Manual included with this unit.
1
Summit Appliance, Div. of Felix Storch, Inc. &middot; Bronx, NY 10474 &middot; Tel: 718-893-3900 &middot; Fax: 844-478-8799
">

Hello! I am an AI chatbot specifically trained to assist you with the Summit DW18 Instructions. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!

Show related prompts

Assistant typing

Assistant is out of keyboard. Please, try again later.

Key features

Stainless steel panel pre-installed
Custom panel installation
Detailed instructions
Safety guide

Frequently asked questions

Follow the steps outlined in the document, starting with opening the door and placing support under it. Remove the screws labeled as A, B, & C, detach the panel mounting bracket, and disconnect the ground wire before removing the screws labeled "E".

Do not remove the screws that hold the lock in place at the top of the door.

Refer to Page 16 of the Installation Manual included with the unit.