Aquafaucet 6097 Touch On Faucet Installation Manual

(0) BWE
DESCRIPTION
e Brass construction
e Flexible supply lines with 3/8”
fittings
* Includes Red/Blue indicators
CARTRIDGE
e Ceramic disk cartridge
STANDARDS
e Certified to CUPC
* Certified to AB1953
* Certified to NSF/ANSI 61
« ADA for lever handle
i
T L 3. 9inch
ë
= i 5. linch
!
. 3 |
—
Specifications
Bon
Single-Handle Vessel Sink Faucet Installation
Up
Cc
8. Tinch
| =
1.57inch
CRITICAL DIMENSIONS
Single—Handle Vessel Sink Faucet Installation
HF
Adjustable wrench
‹
Hexagon wrench
INSTALLATION MANUAL Tools:
A
wrench
Notes before installation :
1.Please check that all components
are present,
2.Before installation ensure that all
feed lines are clear of debris and
on/off valve is present.
20-125 PSI (includes combination
of hot and cold feed lines),
4.Pictures in the manual are
general in content and may not
represent exactly your purchased
faucet. If you are having
difficulties please contact a
professional plumber.
5.1f you will be away from home
shut off the main water supply.
Daily maintenance
1.Use a soft cloth and vinegar to
remove hard-water spots.
2.Check aerator (if present)
regularly for calcium build up are
when water stream is not
optimum.
3.00 NOT use caustic cleaning
products as the use will break
down finish and will void the
product warranty.
4.Acceptable cleaners include
vinegar or mild non-abrasive
liquid detergents.
5.1f the water pressure appears to
be less than optimum remove,
inspect,clean or replace aerator.
Warning
(1) NO TAPE NEEDED FOR INSTALLATION
If when the flowing water get small
or even none Please first check and
clean the hot and cold water pipe.
3.Ensure water pressure is between
for an extended period you should
ring {
1. Remove the rubber washer, metal
washer and locking nut from the
faucet.
2. Screw and hand tighten the hot and
cold flexible hoses to the faucet. DO
НОТ use a wrench to tighten hoses as
this may damage the hose and/or the
hose threads.
a
"a
3. Install faucet through center hole .
4. Re-install the rubber washer followed
by the metal washer and lock-nut.Hand
tighten then tighten further using a
screw driver to tighten lock-nut screws.
a
HOT
—
5.Attach flexible hose to water supply,
Run the hot and cold valve
at least 15 seconds to
clear it before connect
Noise could be significantly
reduced by adjusting the
valve water flow
1-1 Installation Sketch
1-2 Installation Steps
With Overflow
Without Overflow
Vessel Sink/Drain InstalLation(Overflow)
la ———
Installation as shown in the figur
Vessel Sink/Drain Installation (non—-Overflow)
+
%
EE ADE
1 Drain Cap
2 Silicon Gasket
3 Sponge Gasket
4 Silicon Gasket
5) Drain Body
E Overflow
7 Silicon Gasket
=
8 Plastic Washer
9 Brass Locking Nut
10 Rubber Ggsket
Il Locking Nut
12 Tail Pipe
Counter Top
T
Installation as shown in the figure