Eval Kit Manual
AS7265x Multispectral
Chipset
Evaluation Kit User Guide
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 1
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
6
7
4
5
8
3.1
3.2
3.3
3.4
2
3
1
1.1
Content Guide
Introduction ........................................................................................................................ 3
Kit Content ......................................................................................................................... 3
Getting Started .................................................................................................................. 3
Hardware Description ........................................................................................................ 4
Hardware Architecture ....................................................................................................... 4
Power Supply .................................................................................................................... 5
Interface to Controller ........................................................................................................ 5
LEDs .................................................................................................................................. 6
Software Description .......................................................................................................... 7
AS7265x Multispectral Chipset Schematics ....................................................................... 8
Ordering & Contact Information ......................................................................................... 9
Copyrights & Disclaimer .................................................................................................. 10
Revision Information ........................................................................................................ 11
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 2
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
1 Introduction
AS7265x Multispectral Chipset Evaluation Kit provides a platform to evaluate ams AS7265x
Multispectral Chipset products with the Spectral Sensor Dashboard software running on a Windows personal computer. This user guide describes the features and functions of AS7265x Multispectral
Chipset evaluation kit.
Note, the described Kit with the hardware release 1V1 is based on the generation 1 of the
Multispectral Chipset. Therefore, please check in case of any firmware update if the firmware release is compatible to this hardware release For more details see the application note “AS7265x Design considerations”.
1.1 Kit Content
The following items are delivered with this Evaluation Kit.
Figure 1. Kit Content
2 3
1
Pos. Item
1 USB Cable
2
3
AS7265x Multispectral Chipset Board
USB Data Stick
Comment
USB – UART Cable with MicroUSB Connector
Evaluation Board
Documents and Software
2 Getting Started
The demo kit requires one time installation of FTDI Virtual COM Port Driver for the USB cable as well as ActiveState ActiveTcl Community Edition for the dashboard software if both are not already installed on the computer. Both installation files can be found in the USB Data Stick. If there is an issue about the installation, please refer to www.ftdichip.com
and www.activestate.com
for more information.
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 3
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
The Dashboard software does not require an installation. Please copy the following files to any folder you would like to work with and double click the “.tbc” file to start the GUI.
Figure 2. Dashboard Software Files
# File Comment
1 ams_Spectral_Sensor_Dashboard_x.x.xx.tbc Tcl file with revision x.x.xx
2 ams_logo_xparent_h30.gif ams logo
3 Hardware Description
The AS7265x Multispectral Chipset board by default consists of the UART interface, the LDO for 3.3V supply, AS72651/AS72652/AS72653 devices with associated flash memory, and the programming header for the flash memory.
If you would like to evaluate AS7265x Multispectral Chipset products with an I
2
C interface, the board also has the option for that. Please refer to the next section.
3.1 Hardware Architecture
Figure 3. Board Block Diagram
LDO
3V3
5V 3V3
PC
Terminal
MicroUSB
UART
AS72651
I2C
AS72652
AS72653
SPI
Memory
Figure 4. Connectors and LEDs
A
C
B
D ams Eval Kit Manual
[v1-07] 2018-May-23
Page 4
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
Pos. Designator
A J1
B
C
AS72651, D9
AS72652/3,
D12/13
Comment
MicroUSB Connector; Connect to a personal computer;
AS72651 with Place Holders for the LED;
AS72652/3 with Place Holders for the LEDs;
D J2 Flash Memory Programming Header;
3.2 Power Supply
The AS7265x Multispectral Chipset board will be powered up from the MicroUSB cable that connects to personal computer. The onboard LDO converts 5V USB power to 3.3V for the chipsets.
3.3 Interface to Controller
AS7265x Multispectral Chipset board by default has UART interface to a controller. A user could get the sensors data with the Dashboard software. J1 is the MicroUSB connector that connects the cable to a computer for UART interface. The cable has an internal USB-UART convertor.
With a minor modification, I 2 C interface can be supported. The test points in next Figure could be used for I 2 C connection. The test point, TX, should be connected to SDA and the test point, RX, should be connected to SCL. Also R3/R4 are for I 2 C pull up resistors.
R17 and R18 would pull I 2 C_ENB pin of AS72651 up or down for selecting UART or I2C interfaces.
Install R17 for I
2
C interface and install R18 for UART interface.
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 5
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
3.4 LEDs
Some of customer applications require external LEDs as the light source. The AS7265x Multispectral
Chipset demo board has some place holders for this purpose. Each LED is series with a current limit resistor. By default, the LEDs and the resistors are not populated.
A generic application of AS7265x is to shine light rays to a target and AS7265x produces outputs based on the reflected light rays as shown in the above figure. So LED selection is determined by the spectral responsivity of reflected light and characteristics of the target. For example, if the target is expected to absorb 680nm light and the application needs to distinguish the target from others, a broadband white LED might be used as the light source with AS72651 and the 680nm channel should be checked. Various applications may require different light sources. The place holders for LEDs are
D9, D12, and D13. D9 is connected to AS72651 and ATLED0 = 100/0 turns D9 ON/OFF. D12 is controlled by AS72652 and ATLED2 = 100/0 turns it ON/OFF. D13 is controlled by AS72653 and
ATLEDE = 100/0 turns it ON/OFF. The AS7265x device supports various LED currents, 12.5mA,
25mA, 50mA, or 100mA. ATLEDC = 0/16/32/48 (decimal) sets the current through D9 to
12.5mA/25mA/50mA/100mA. Similarly ATLEDD sets the current of D12 and ATLEDE sets the current of D13.
The LED currents can be also controlled and configured with the virtual I
2
C registers, 0x07 (the register address 0x87 for write) for D9, 0x2E (the register address 0xAE for write) for D12, and 0x2F
(the register address 0xAF for write) for D13.
Addr: 0x07/0x87
Bit
7:6
Bit Name
RSVD
5:4 ICL_DRV
3
2:1
LED_DRV
ICL_IND
Default Access
0
00
0
00
R
LED Control
Reserved
Bit Description
R/W LED_DRV current limit
‘b00=12.5mA; ‘b01=25mA; ‘b10=50mA;
‘b11=100mA;
R/W Enable LED_DRV
1: Enabled; 0: Disabled
R/W LED_IND current limit
‘b00=1mA; ‘b01=2mA; ‘b10=4mA; ‘b11=8mA;
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 6
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
Addr: 0x07/0x87
0 LED_IND 0
LED Control
R/W Enable LED_IND
1: Enabled; 0: Disabled
Since the power to the LEDs is 5V, the actual current through LEDs might be smaller if the forward of LED is high. If this is the case, please connect the LED with an external power and pick the serial resistor value based on the forward voltage of the LED and the desired LED current. Please refer to the LED I-V curve specification. If the forward of LED is low, the current limit resistor can be installed with 0Ω.
4 Software Description
It would be easier to evaluate AS7265x Multispectral Chipset solution with AT commands through
UART interface. The Spectral Sensor Dashboard software running on a Windows computer would be ideal. The USB Data Stick has the application note for the Spectral Sensor Dashboard software.
For I 2 C interface, the platform provides the option to connect to I 2 C interface and a customer would need to develop a program to read the sensors data.
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 7
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
5 AS7265x Multispectral Chipset Schematics
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 8
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
6 Ordering & Contact Information
Ordering Code Description
AS7265x Demo Kit AS7265x Multispectral Chipset i-SPI-B Evaluation Kit
Buy our products or get free samples online at:
www.ams.com/ICdirect
Technical Support is available at:
www.ams.com/Technical-Support
Provide feedback about this document at:
www.ams.com/Document-Feedback
For further information and requests, e-mail us at:
[email protected]
For sales offices, distributors and representatives, please visit:
www.ams.com/contact
Headquarters
ams AG
Tobelbaderstrasse 30
8141 Unterpremstaetten
Austria, Europe
Tel: +43 (0) 3136 500 0
Website: www.ams.com
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 9
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
7 Copyrights & Disclaimer
Copyright ams AG, Tobelbader Strasse 30, 8141 Unterpremstaetten, Austria-Europe. Trademarks
Registered. All rights reserved. The material herein may not be reproduced, adapted, merged, translated, stored, or used without the prior written consent of the copyright owner.
Demo Kits, Evaluation Kits and Reference Designs are provided to recipient on an “as is” basis for demonstration and evaluation purposes only and are not considered to be finished end-products intended and fit for general consumer use, commercial applications and applications with special requirements such as but not limited to medical equipment or automotive applications. Demo Kits,
Evaluation Kits and Reference Designs have not been tested for compliance with electromagnetic compatibility (EMC) standards and directives, unless otherwise specified.
Demo Kits, Evaluation Kits and Reference Designs shall be used by qualified personnel only. ams AG reserves the right to change functionality and price of Demo Kits, Evaluation Kits and
Reference Designs at any time and without notice.
Any express or implied warranties, including, but not limited to the implied warranties of merchantability and fitness for a particular purpose are disclaimed. Any claims and demands and any direct, indirect, incidental, special, exemplary or consequential damages arising from the inadequacy of the provided Demo Kits, Evaluation Kits and Reference Designs or incurred losses of any kind (e.g. loss of use, data or profits or business interruption however caused) as a consequence of their use are excluded. ams AG shall not be liable to recipient or any third party for any damages, including but not limited to personal injury, property damage, loss of profits, loss of use, interruption of business or indirect, special, incidental or consequential damages, of any kind, in connection with or arising out of the furnishing, performance or use of the technical data herein. No obligation or liability to recipient or any third party shall arise or flow out of ams AG rendering of technical or other services.
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 10
Document Feedback
AS7265x Multispectral Chipset
Evaluation Kit User Guide
8 Revision Information
Changes from previous version to current revision 1-07 (2018-May-23)
Updated LED Section – ATLEDx functions in text
Multispectral Sensor Kit Generation 1 and limitations
Note:
Page numbers for the previous version may differ from page numbers in the current revision.
Correction of typographical errors is not explicitly mentioned.
ams Eval Kit Manual
[v1-07] 2018-May-23
Page 11
Document Feedback
