MyBinding Best-Rite 505-3 Assembly Instruction

Best-Rite 3' Best-Bite

Tackless Paper Holder - 6pk

Instruction Manual

BESTBITE-12-NL

Part List

P1 Best-Bite 1 EA

Should you require assistance during assembly, please call our

Customer Service Department

Monday- Friday 8 a.m.-5 p.m. CST

1-800-749-2258

A

B

C

D

E

Hardware List

Mounting Bracket 6 EA

Screw 6 EA

Screw Anchor-Concrete 6 EA

Magnet Strip None

Double Sided Tape 6 EA

There are Two Ways to Install Your New Best-Bite.

Option One

2

P-1

2

Length

B

A

Best Bite Location

C

A

1.

Locate and

Drill 2 pilot holes using 1/4” drill bit.

2.

Install two Screw Anchors(C) and two Mounting Brackets(A) using two Screws (B).

3. Snap the Best-Bite (P1) over the Plastic Bracket (A) as shown in Illustration #3.

Illustration # 3

Option Two

1.

Peel off protection paper

from one side of Double

Sided Tapes (E).

See Illustration #4

Protection

Paper

2.

Wipe off the back of Best-Bite (P-1) to remove all particles. Place the tape’s peeled sides on to the back of the unit in even spaces, and remove the other protection paper from the Double

Sided

Tapes (E). See Illustration #5.

Protection

Paper

3.

Wipe off the surface where

Best-Bite(P1) will be installed.

Press the unit with the exposed

Double Sided Tape against the wall surface. See Illustration #6.

Illustration # 6

P-1

Illustration # 4 E E

E

Illustration # 5

P-1

WWW.MYBINDING.COM