advertisement
DESCRIPTION OF PRODUCT
Fast Cool Function
Press the "Temperature" button for 3 seconds to cool the refrigerator compartment quickly, or 6 hours before placing large quantities of fresh food in the freezer compartment. When the function is active, the yellow light is on and the three green lights are off. This function is automatically deactivated after 30 hours, or manually by pressing the button again for 3 seconds. When the function is not active, the yellow light is off and the indication of the set temperature is shown by the green lights.
Note: Do not place fresh food to be frozen in direct contact with already frozen food.
Fan (where provided)
The fan is factory set to ACTIVE.
The fan can be deactivated by pressing the button on the base (as shown in the figure). If the room temperature exceeds 27°C or if water droplets form on the glass shelves, the fan must be on in order to guarantee the correct preservation of food. Deactivation of the fan enables energy consumption to be optimised.
On / Off
Press to activate/deactivate the appliance.
Note: This operation does not disconnect the appliance from the power supply.
Refrigerator compartment temperature
The three green lights indicate the set refrigerator compartment temperature.
A different temperature can be set using the "Temperature " button.
The following adjustments are possible:
LED's on Set temperature
High (least cold)
Medium-high
Intermediate
Medium-low
Low (coldest)
GB
Refrigerator Compartment
A.
Fan and antibacterial and antiodour filter (depending on the model)
B.
Lamp or LED light (depending on the model)
C.
Shelves
D.
LED lights (depending on the model)
E.
Crisper drawer cover
F.
Crisper(s)
G.
Rating plate (located at side of crisper)
H.
Control panel
N.
Dairy compartment
O.
Door trays
P.
Bottle holder (if provided)
Q.
Bottle bin
Least cold zone
Intermediate zone
Coldest zone
Fruit and vegetable zone
Freezer Compartment
I.
Top drawer (freezing area)
L.
Middle and bottom drawers (storage area for frozen and deep frozen food)
M.
Ice cube tray (if provided)
Note: All shelves, door trays and racks are removable.
The ideal temperatures for preserving foods are already factory-set.
What to do if...
The control panel is switched off, the appliance does not work.
The inside light does not work.
Possible causes:
The appliance could be in off mode.
There may be an appliance power supply problem.
The light may need replacing.
The temperature inside the compartments is not low enough.
There could be various causes (see "Cures")
There is water on the bottom of the refrigerator compartment. The defrost water drain is blocked.
The front edge of the appliance, at the door striker seal, is hot. This is not a defect It prevents condensation from forming.
One or more indicator lights flash.
Malfunction alarm
The alarm indicates a fault in a technical component.
Carefully read the user handbook provided before using the appliance.
The characteristics, technical data and images may vary according to the model.
Cures:
Activate the appliance with the On/Off button
Make sure:
- there is not a power outage
- the plug is properly inserted in the power socket and the mains double-pole switch (if present) is in the correct position
(i.e. allows the appliance to be powered)
- the household electrical system protection devices are efficient
- the power cable is not broken.
Models with lamp: disconnect the appliance from the power supply, check the lamp and, if necessary, replace it with a new one (see the section "Lamp or LED replacement").
Models with LED lights: contact the authorised Service Centre.
Make sure:
- the doors close properly
- the appliance is not installed near a heat source
- the set temperature is adequate
- the circulation of air through the vents at the bottom of the appliance is not obstructed
Clean the defrost water drain hole (see the section "Appliance Maintenance and Cleaning")
No remedy is necessary.
Call the authorised Service Centre.
The appliance continues to maintain minimum preservation conditions.
D GB F NL E P I GR S N DK FIN 5019 608 01100
advertisement
Related manuals
advertisement