FAAC XM100 User Manual

XM100

USER’S GUIDE

UNIVERSAL MOTION SENSOR FOR AUTOMATIC DOORS

1 General

SENSITIVITY

ADJUSTMENT

Vertical angle: 30°

Mounting height: 2.2m

1

Width of the sensing field: choice of antenna

LED

- LED flashes for a few seconds after power-on.

- LED lights up when the sensor detects motion.

WIRING

GREEN Power supply +12V-24V

BROWN Ground 0V

WHITE Output contact 1 NO

YELLOW Output contact 2 COM

2

Position of detection field: adjust the lateral angle of the planar antenna

3

Depth of detection field: adjust the vertical angle of the planar antenna

1/2

3 Installation

Avoid vibrations!!!

Do not cover the sensor! Avoid moving objects in proximity of the sensor!

Avoid HF lamps and fluorescent lighting in proximity of the sensor!

Do not remove the protection which avoids contact with the electronical parts!

4 Troubleshooting

SYMPTOMS

The door will not open and no red LED lights up.

POSSIBLE CAUSES

The sensor power is off.

CORRECTIVE ACTION

Check the wiring and the power supply.

The door opens and closes constantly. 1. The sensor "sees" the door moving. Increase the tilt angle and/or reduce the sensitivity.

The door will not close.

Red LED OFF

2. Closing the door creates vibrations picked up by the sensor.

1. On-Off switch at door control is in wrong position or faulty.

2. Improper output configuration

Ensure that the sensor is correctly fixed.

Make sure that On-Off switch for door is in the ON or

AUTOMATIC position.

Check the output configuration setting on each sensor connected to the door operator.

5 Technical

Technology

Transmitter frequency

Transmitter radiated power

Transmitter power density

Mounting height

Tilt angles

Detection area (mounting height = 2.2 m)

Detection mode

Minimum speed

Supply voltage

Power consumption

Output (electronic relay)

Max. current

Max. voltage

Temperature range

Norm Conformity

Degree of protection

Material

Color of head housing

Dimensions

Weight

Length of cable

: microwave and microprocessor

: 24.175 GHz

: <20 dBm EIRP

: < 5 mW/cm²

: from 1.8 m to 3 m

: 0° to 90° vertical and -30° to + 30° lateral

: 4m (W) x 2m (D)

: motion

: 5 cm/s (measured in the sensor axis)

: 12V to 24V DC +30% / -10%

: < 2W (VA)

: 250 mA

: 50 VDC/VAC

: -20°C to +55°C

: R&TTE 1999/5/EC; EMC 2004/108/EC

: IP54

: ABS & Polycarbonate

: black smoked, aluminum

: 80 mm (W) x 60 mm (H) x 55 mm (D)

: 140g

: 2.5m

Specifications are subject to changes without prior notice

The declaration of conformity is available on our website: www.faac.it

FAAC S.p.A . - Via Benini, 1 40069 Zola Predosa - Italia - tel. +39 051 61724 - fax. +39 051 758518 - www.faacgroup.com

2/2