1.
2.
3.
4.
5.
6.
7.
8.
FAAC Instruc�ons
Open your motor/control panel which will either be located on the gate motor or will be inside of a box mounted to
wall close to the motor.
Once the cover has been removed, please located the receiver board which is a small circuit board a�ached to a
larger circuit board.
Once you have iden�fied the receiver board you must locate the learn bu�on (please see image below)
Push the learn bu�on one and release.
A red light will illuminate for 10 seconds.
Now push and hold the bu�on you wish to control the gate on your new remote for 2-3 seconds and the light on the
receiver will flicker to indicate the remote has been learnt.
Test your new remote to ensure it operates the gate.
If you have purchased addi�onal remotes, please repeat steps 4-7 for each remote.
1. Press and hold the + or Logic bu�on located on the right of the motor. Whilst s�ll holding + or Logic, press the setup
bu�on below and the Radio 1 LED will begin to flash.
2. Let go of both bu�ons and push and hold the bu�on on the new remote that you wish to operate the door.
3. Once the Radio 1 LED has stopped flashing you can release the remote bu�on.
4. Test the remote.
www.remotepro.com.au
">
