advertisement
![Comnet CL(L,R)FE(X)POE(C,U) Series Datasheet | Manualzz Comnet CL(L,R)FE(X)POE(C,U) Series Datasheet | Manualzz](http://s1.manualzz.com/store/data/066164174_1-1952804caf6cdc44b6cacf0435fab3b8-360x466.png)
Ethernet-over-Copper Extender With 30W PSE PoE+
CopperLine® CL(L,R)FE(X)POE(C,U)
-40˚ TO + 65˚ C 802.3at
802.3af/at EXTENDER 30W
The ComNet CopperLine® Ethernet over copper line supports up to sixteen channels of 10/100Mbps Ethernet with PoE+ Power Injection and Passthrough PoE+ over twisted pair cable (CAT-5, UTP) or over coax. With the ability to connect directly to a PoE+ switch, or the ability to generate PoE+ power with a 48 to 56 V input* to either the Local or Remote ends, these units provide the ultimate flexibility for extending a powered device (PD) over long distance copper. A complete set includes both a Local and Remote module.
Remote units are available in small package sizes that include one or four channels, and Local modules are available in the same packages as well as a
1RU rack for larger channel counts.
FEATURES
› Transmits individual Ethernet data channels with PoE+
Power Injection or Pass-through PoE+ over standard
UTP or Coaxial cable
› Extends Ethernet up to 3,000 feet (914 m) at 10 Mbps or
2,000 feet (610 m) at 100 Mbps over UTP cable
› Extends Ethernet up to 5,000 feet (1,524 m) at 10 Mbps or
2,000 feet (610 m) at 100 Mbps over Coaxial cable
› Extended temperature operation from -40°C to +65°C
› Extended Pass-through PoE meets the IEEE 802.3at standard for Power over Ethernet
› Full 10/100 Mbps Bandwidth
› Supports Multicast, Unicast and Jumbo Frame
› Symmetric Bandwidth provides consistent upload and download with virtually zero packet loss over the total usable distance
› Type tested to RFC-2544 TCP/IP network bandwidth packet transmission standards
› User-selectable data rate for maximum bandwidth and transmission distance utilization
› Complies with all major IEEE standards and RFC network protocols for UDP, TCP/IP, HTTP/HTTPs
› Tested and certified† by an independent laboratory for full compliance with the environmental requirements (ambient operating temperature, mechanical shock, vibration, humidity with condensation, high-line/low-line voltage conditions and transient voltage protection) of NEMA TS-1/TS-2 and
CALTRANS Traffic Signal Control Equipment Specifications.
› LED status indicators confirm operating status
› Available in small-size, ComFit interchangeable stand alone or 1RU high rack mounted models
› Designed and manufactured in the USA
› Lifetime Warranty
APPLICATIONS
› Retrofit existing analog CCTV installations to Ethernet- based systems
› CCTV systems for casinos, airports, school campuses
* Power Supply for PoE applications is sold separately.
† One Channel Units Only. Multichannel units are designed to meet
NEMA TS-2 Spec.
LIFETIME WARRANTY
WWW.COMNET.NET
TECH SUPPORT: 1.888.678.9427
CL(L,R)FE(X)POE(C,U) Ethernet-over-Copper Extender With 30W PSE PoE+
AGENCY COMPLIANCE
SPECIFICATIONS
Ethernet
Data Interface
Data Rate
RFC
Standards
Transmission Distances¹
10/100BaseT(X) Ethernet
DIP-switch selectable 10/100Mbps
Full data rate / full duplex up to the maximum rated distance
2544 TCP/IP Packet Transmission
IEEE 802.3af/at PoE+,
RFC: 768 UDP, 2068 HTTP, 793 TCP
791 IP, 1783 TFTP, 894 IP over Ethernet.
See chart below
Connectors
Ethernet RJ-45
Extended Distance
Operating Power
Coaxial (C): female BNC
Ethernet (U): RJ-45
Powered by PoE or 4-pin screw terminal for local power or power injection
Power
Pass-Through Mode
Power Injection Mode
Current Protection
1 CH: Operates on PoE power
or optional 9 to 36 VDC or 24 VAC, 1.5 W
4 CH: 9 to 15 VDC, 6 W
8 CH: 12 to 15 VDC, 12 W
16 CH: 12 to 15 VDC, 24 W
1 CH: 48 to 56 VDC, 30 W
4 CH: 48 to 56 VDC, 120W & 9 to 15 VDC, 6W
8 CH: 48 to 56 VDC, 240W & 12 to 15 VDC, 12 W
16 CH: 48 to 56 VDC, 480 W & 12 to 15 VDC, 24 W
Automatic Resettable Solid-State Current Limiters
Mechanical
LED Indicators
Circuit Board
Size (L×W×H)
Number of Rack Slots
Shipping Weight
Operating Power PoE Power
Ethernet Link and Activity
Ethernet Speed
Extended Link and Activity
Meets IPC Standard
1 CH: 3.3 × 2.5 × 1.1 in (8.4 × 6.4 × 2.8 cm)
4 CH: 6.1 × 5.3 × 1.1 in (15.5 × 13.5 × 2.8 cm)
8+ CH: 6.1 × 19 × 1.75 in (15.5 × 48.26 × 4.45 cm)
1 (4CH Version Only)
1 CH: <1 lbs / 0.5 kg
4 CH: <2 lbs / 0.9 kg
8+ CH: <5 lbs / 2.3 kg
Environmental
MTBF
Operating Temp
Storage Temp
Relative Humidity
>100,000 hours
– 40˚ C to +65˚ C
– 40˚ C to +80˚ C
0% to 95% (non-condensing)²
[1] Distance figures are based on a 50 V PSE PoE power source, and external power supplies for the extenders. Distance figures are obtained using in-house testing mirroring installations.
Factors such as coaxial and copper cable quality, the number of connectors and splices in the cable run, the use of PoE, and environmental conditions encountered within the installation might affect the actual transmission distance and should be taken into consideration. When using UTP models Pass-Through PoE and
Local PoE Injection is only possible in 4-pair mode.
ORDERING INFORMATION
Part Number
CLLFE1POEC
CLRFE1POEC
CLLFE1POEU
CLRFE1POEU
CLLFE4POEC
CLRFE4POEC
CLLFE4POEU
CLRFE4POEU
CLLFE8POEC
CLLFE8POEU
CLLFE16POEC
CLLFE16POEU
Accessories:
Options
Description
1 Port EOC Ethernet Extender
Position
Local
Channels Form Factor
1 Small Size
Cable
Coax
1 Port EOC Ethernet Extender
1 Port EOU Ethernet Extender
1 Port EOU Ethernet Extender
4 Port EOC Ethernet Extender
4 Port EOC Ethernet Extender
4 Port EOU Ethernet Extender
Remote
Local
Remote
Local
Remote
Local
4
4
4
1
1
1
Small Size
Small Size
Small Size
ComFit (1 Slot)
ComFit (1 Slot)
ComFit (1 Slot)
4 Port EOU Ethernet Extender
8 Port EOC Ethernet Extender
8 Port EOU Ethernet Extender
Remote
Local
Local
4
8
8
ComFit (1 Slot)
1 RU 19” Rack Mount
1 RU 19” Rack Mount
UTP
Coax
UTP
16 Port EOC Ethernet Extender Local 16 1 RU 19” Rack Mount Coax
16 Port EOU Ethernet Extender Local 16 1 RU 19” Rack Mount UTP
Unit-appropriate power supply (Included, for benign 0 to 50ºC applications only. Hardened power supply available, consult factory). For PoE injection sold separately 48-56VDC PSU is required.
48 Volt DC Plug-in Power Supply (extra charge, consult factory)
[2] Add suffix ‘/C’ for Conformally Coated Circuit Boards to extend to condensation conditions (Extra charge, consult factory)
DIN-Rail Mounting Adaptor Kit - With Mounting Hardware (Optional, order model DINBKT1 or DINBKT4) (Suitable for 1CH and 4CH units only)
Coax
UTP
UTP
Coax
Coax
UTP
In a continuing effort to improve and advance technology, product specifications are subject to change without notice.
LIFETIME WARRANTY
WWW.COMNET.NET
TECH SUPPORT: 1.888.678.9427
CL(L,R)FE(X)POE(C,U) Ethernet-over-Copper Extender With 30W PSE PoE+
MAXIMUM TRANSMISSION DISTANCES
1
Media
Data Rate 10M
COAX - RG59/U
100M 10M
UTP - 4 pair
100M 10M
UTP - 1 pair
100M
Source Power
Non-PoE Max.Distance
PoE CLASS2 (6.5W)
PoE CLASS3 (13W) 1
1
PoE CLASS4 (25.5W) 1
1
15W
750 ft
(228 m)
N/A
5,000 ft
30W
1,524 m
3,000 ft
(914 m)
3,000 ft
(914 m)
850 ft
(259 m)
335 ft
(102 m)
15W 30W
2,000 ft
2,000 ft
610 m
(610 m)
750 ft
(228 m)
N/A
2,000 ft
(610 m)
850 ft
(259 m)
335 ft
(102 m)
15W
3,000 ft
914 m
(914 m)
750 ft
(228 m)
N/A
3,000 ft
30W
3,000 ft
(914 m)
850 ft
(259 m)
335 ft
(102 m)
15W
750 ft
(228 m)
N/A
2,000 ft
2,000 ft
610 m
(610 m)
30W
2,000 ft
(610 m)
850 ft
(259 m)
335 ft
(102 m)
3,000 ft
914 m
N/A
N/A
N/A
N/A
1,000 ft
305 m
[1] Distance figures are based on a 50 V PSE PoE power source, and external power supplies for the extenders. Distance figures are obtained using in-house testing mirroring installations. Factors such as coaxial and copper cable quality, the number of connectors and splices in the cable run, the use of PoE, and environmental conditions encountered within the installation might affect the actual transmission distance and should be taken into consideration. When using UTP models Pass- Through PoE and Local PoE Injection is only possible in 4-pair mode.
MAXIMUM TRANSMISSION DISTANCES WITH 54V INPUT (CL(L,R)FE1POEU ONLY)
Media COAX - RG59/U UTP - 4 pair
Data Rate 10M 100M 10M
Source Power
PoE Up to 25W
15W
N/A
30W
N/A
15W
N/A
30W
N/A
15W
N/A
30W
1000 ft (305 m)
15W
N/A
100M
30W
1000 ft (305 m)
Running multiple signals in the same twisted pair cable could affect signal quality and is not recommended.
TYPICAL APPLICATIONS
PoE Pass-Through Mode
See Chart Above
10 or 100 Mbps
PoE Switch
CLLFE1POE(C,U) CLRFE1POE(C,U)
Cat-5 Cable
Twisted Pair / Coax
PoE Power
PoE Camera
PoE Pass-Through Mode with Multiple Remote Units
10 or 100 Mbps
PoE Switch
CLLFE4POE(C,U) See Chart Above
CLRFE1POE(C,U)
CLRFE1POE(C,U)
CLRFE1POE(C,U)
CLRFE1POE(C,U)
PoE Camera
PoE Camera
PoE Camera
PoE Camera
12 VDC
Local PoE Injection Mode
See Chart Above
10 or 100 Mbps
Switch
CLLFE1POE(C,U) CLRFE1POE(C,U)
48 to 56VDC
Remote PoE Injection Mode
10 or 100 Mbps
Switch
PoE Camera
See Chart Above
CLLFE1POE(C,U) CLRFE1POE(C,U)
12 VDC 48 to 56VDC
PoE Camera
3 CORPORATE DRIVE | DANBURY, CONNECTICUT 06810 | USA | T: 203.796.5300
| F: 203.796.5303
| TECH SUPPORT: 1.888.678.9427
SUITE 7, CASTLEGATE BUSINESS PARK | CALDICOT | SOUTH WALES, UK NP26 5AD | T: +44 (0) 2036 300 695 | F: +44 (0)113 253 7462 | [email protected]
© 2022 Communication Networks. All Rights Reserved. “ComNet” and the “ComNet Logo” are registered trademarks of Communication Networks.
25 May 2022
advertisement
Related manuals
advertisement