Tech Lighting Arris 5-Light Bath Instructions

Add to My manuals
2 Pages

advertisement

Tech Lighting Arris 5-Light Bath Instructions | Manualzz

Installation Instructions for

Arris 4-Light and 5-Light Bath

920BCARRIS

700 BC ARS4_, 700BCARS5_

1.1

B ATH C OLLECTION

G P I :

This fixture is intended to be installed utilizing NEC compliant junction boxes.

This product is suitable for damp locations.

This product can be dimmed with a low-voltage electronic dimmer.

Install the Fixture

1A

1

ALLEN

WRENCH

FIXTURE

SCREW 1

This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.

Use minimum 90°c supply conductors.

1C

ANCHOR

MOUNTING

PLATE

1 1

1 Remove the fixture screws located on the top and bottom of the fixture base with the provided Allen wrench.

2

1B

Remove the mounting plate from the fixture base.

3

ANCHOR

4 Verify that the mounting plate is level before continuing.

5 Line an anchor tip with the center of an anchor hole, and push the anchor into the wall up to the threads.

6 Screw the anchor in the rest of the way with a Phillipshead screwdriver.

7 Repeat for the other anchor hole.

3

#8-32 SCREW

3 Install the mounting plate onto the electrical box with the two #8-32 screws provided.

1

1D

ANCHOR

1C

ANCHOR

6

4

SCREW

WASHER

5

8 Slide a #8 screw through a washer, and screw it into an anchor to secure the fixture base to the wall. Repeat for the other anchor.

1B

8

4 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes.

5 Connect the black fixture wire to the hot power line wire with a wire nut.

6 Connect the white fixture wire to the neutral power line wire with a wire nut.

7 Mount the fixture by sliding it back onto the mounting plate and reinstalling the fixture screws (reversal of figure 1A).

7 Mount the fixture by sliding it back onto the mounting plate

8 If desired, reposition the fixture up or down, if vertical or left or right, if horizontal; then reinstall the fixture screws (reversal of figure 1A).

SAVE THESE INSTRUCTIONS!

2

7400 Linder Ave, Skokie, IL 60077

847.410.4400

www.techlighting.com

© 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.

A Generation Brands Company

advertisement

Related manuals

Download PDF

advertisement