MODEL PART DIAGRAM

Grill

Button Control

Section

Unit

User

Manual

Side Vent

Rear Panel

Front Panel

(2) Pre-Filter

(2) Washable AOC™

Carbon Filter

(2) True HEPA Filters

Alexa Setup

Guide /

Wi-Fi Setup

Guide

WHERE TO USE

12~18 in 12~18 in

Allow 12 ~ 18 in. of space between TVs, radios, and other electronics

Electromagnetic interference from certain electronics may cause product malfunction.

Place indoors away from direct sunlight

Direct exposure may cause product malfunction or failure.

Only place on hard, flat surfaces

Flimsy or slanted surfaces may result in abnormal noise and vibrations.

Allow at least 12 ~ 18 in. from walls for maximum air flow

4-STAGE AIR PURIFICATION

Air Purification means it removes inanimate particles

01 Pre-Filter 02 Washable AOC™

Carbon Filter

03 True HEPA Filter 04 PlasmaWave ®

CONTROL PANEL

01. Auto Mode Indicator

The LED "Auto" light will indicate when Auto Mode is activated.

02. Fan Speed Indicator

Indicates the current fan speed.

03. Sleep Mode Indicator

When Sleep Mode is activated, the Air Quality

Indicator LED light is disabled.

Fan speed will automatically set to minimum speed(lower than 'Low') which will be nearly silent.

When Sleep Mode is active, Plasmawave ® disabled, but it can be turned back on.

04. Air Quality Indicator

will be

Color coded LED light indicates one of four levels of

Air Quality: Red (poor), Amber (fair), Green (average), and Blue (good).

05. PlasmaWave ® Indicator

Indicates whether PlasmaWave ® is enabled or disabled.

06. Wi-Fi Indicator

• Enables or disables the Wi-Fi feature.

• When in the pairing state, the Wi-Fi LED flashes.

07. Filter Replacement Indicator

LED light indicates when it is time to change the filter.

08. Light Sensor

Detects the amount of ambient light in the environment. When in Auto Mode, the Light Sensor detects when to put the unit into Sleep Mode.

09. Power Button

Turns the unit on or off. During the first 30 seconds of powering up, the Air Quality Indicator will cycle through Blue, Green, Amber, and Red colors.

• Smart Sensor takes approximately 4 minutes to detect the air quality in the environment before normal operation begins.

10. Mode Button

Press to cycle through to set the mode of operation

(Auto, Sleep). The unit will default to Auto with

PlasmaWave ® enabled when first powered on.

• Auto Mode automatically adjusts fan speeds according to your indoor air quality. The fan speed will adjust to low when air quality is good, medium when fair, and to high when poor.

11. Sleep Mode Button

When Sleep Mode is activated, the Air Quality

Indicator LED light is disabled.

• Fan speed will automatically set to minimum speed (lower than 'Low') which will be nearly silent.

will be • When Sleep Mode is active, PlasmaWave ® disabled, but it can be turned back on.

12. Plasmawave ® Button

Press the Plasmawave ® button when the unit is on to enable or disable this feature. By default,

Plasmawave ® is enabled whenever the unit is powered on.

"When the unit is running, you may hear a chirping or buzzing sound. The sound is from large particles passing through Plasmawave ® , it is normal and does not signify product failure."

13. Wi-Fi Button

• Press for 3 seconds to activate pairing mode.

• When Wi-Fi is paired, press the button to turn Wi-

Fi off or back on.

14. Filter Reset Button

After replacing the True HEPA Filter, use a small object such as a clip, to press and hold the Filter

Reset Button for at least 5 seconds until the Filter

Replacement Indicator turns off.

INITIAL OPERATION CLEANING CARE

Cleaning the Filters:

1. Remove the front/rear panel by grasping its upper edge and gently pulling forward.

- To remove the front/rear panel, release the latch at the lower edge of the panel.

2. Remove the Pre-Filter, then the plastic bag of filters behind it.

3. Remove filters from protective plastic bag.

4. Install the filters until they fit securely in place.

03. True HEPA Filter (back)

02. Washable AOC™ Carbon Filter (middle)

01. Pre-Filter (front)

5. After filters are installed, close the front panel.

6. Insert the power cord into an electrical outlet.

MAINTENANCE

When to Replace Filters

Filter Indicator Light

Latch

Latch

When to Service

02

01

03

When to Replace

Use a vacuum cleaner or soft brush to clean the

Pre-Filter

• If it is excessively soiled, rinse in room temperature water.

• Do not use detergent or soap.

• Allow the filter to dry for 24 hours or more before using.

• Intervals between filter cleaning may vary depending on the air quality in the environment.

To clean the Washable AOC™ Carbon Filter, remove from the unit and rinse under lightly running room temperature water.

• Do not use detergent or soap.

• Allow the filter to dry for 24 hours or mote before using.

• Do not use hot water over 104ºF.

Pre-Filter none Clean once every 14 days Permanent

Washable AOC™

Carbon Filter none Clean once every 3 months

SPECIFICATIONS

True HEPA Filter Can NOT be WASHED

Lasts Approx. 12 months

Model

Voltage

Power Rate

XLC

AC120V / 60Hz

90 W • When the Check Filter Indicator LED is on, it is time to replace the True HEPA Filter and Washable

AOC™ Carbon Filter.

• Intervals between filter replacement may vary depending on environment.

* Filter performance may decrease after each wash and depending on contamination level prior to washing.

Verified

Room Size

620 sq.ft.

REPLACING FILTERS

Dimensions

Weight

Replacement

Filter

14.6 in(W) × 14.6 in(D)

× 30.6 in(H)

30.6 lbs

Filter X2 / SKU: 1712-0089-03

Resetting Filter Life:

After replacing your True HEPA Filter, place the Pre-Filter back in and close the Front Panel. While the unit is on, use a small, thin object (such as a paperclip) to hold the Filter Reset Button for

X2 at least 5 seconds until you hear the beep. After the beep, the Filter Replacement Indicator will disappear. Your Winix True HEPA is now reset.

The exterior, design, and product specifications may be changed without prior notice to improve product performance.

Cleaning the Exterior & Interior:

Wipe with a soft damp cloth using room temperature water.

• Afterwards, wipe it down with a clean, dry cloth. Open the front panel and clean the interior with a vacuum cleaner.

• For optimal performance, clean every 1 - 2 months.

N O T I C E

• When cleaning the unit, always unplug the power cord first and then wait until the unit has cooled down.

• Never disassemble, repair, or modify the unit yourself.

• Do not use flammable sprays or liquid detergents.

• Do not allow children to clean or maintain the unit.

• Before cleaning or maintaining, ensure unit is unplugged.

• Do not use benzene, alcohol, or other volatile fluids, which may cause damage or discoloration.

Contact Winix for product related inquiries and customer service

• Dedicated Call Center: ☎ (877) 699-4649

• Website: www.winixamerica.com

To expedite service, please specify the model name and number, the nature of the problem, your contact information, and your address.

SAFETY AND CAUTIONS

Before operating this equipment, carefully read and follow these safety cautions.

Ensure filters are inserted before running unit.

Running the unit without filters can shorten the lifespan of the unit and cause electric shock or injury.

Be sure foreign objects are NOT inserted into the vents on the unit.

Objects can include pins, rods, and coins.

Do not touch any part of the interior of the unit with wet hands.

The high voltage may cause electric shock.

Ensure unit intake and outlet vents do not become blocked.

Blockage may lead to increased internal temperatures, causing product failure and deformation.

Do not use the unit as a step stool or place heavy objects on the unit.

Personal injury may occur or product failure and deformation.

W A R N I N G

Follow these instructions to reduce the risk of serious injury or death and to reduce risk of damaging the unit.

• If the power cord is damaged, it must be replaced by a special cord. Reassembly is available from the manufacturer or its service agent.

• This appliance is not intended for use by a person (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge of the unit, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• This unit is not intended to be used to preserve documents or art conservation.

Do not pull on the power cord when unplugging the unit.

Do not tie or knot the power cord when unit is in operation.

If the unit becomes submerged in water, unplug it and contact customer service.

Do not unplug or move the unit while in operation.

Do not plug additional appliances into the same outlet or power supply.

Do not touch the plug with wet hands.

Unplug the unit when not in operation for extended periods of time.

Do not place around heating elements.

Do not use around mist or fumes from industrial oil or around large quantities of metallic dust.

The cord can become damaged by forcefully bending, pulling, twisting, bundling, pinching or placing heavy objects on it.

Do not install in any sort of motor or transport vehicle (trucks, boats, ships, etc.).

Do not place in an area with excessive amounts of noxious gases.

Do not place near any flammable materials

(aerosols, fuel, gases, etc.).

Do not have the unit facing into wind or drafts.

Do not place below any electrical outlet.

Do not place in excessively humid areas where the unit may become wet.

To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.

Do not place unit closer than 12 inches from the wall during operation. It may cause condensation on the wall and the surrounding area.

SAFETY INSTRUCTIONS

Thank you for purchasing a Winix air purifier. This product is for household use only.

IMPORTANT CAUTIONS FOR USING YOUR AIR PURIFIER:

WARNING: Follow the instructions in this manual to reduce the risk of electric shock, short circuit, and/or fire.

• Do not repair or modify the unit. All repairs should be completed by a qualified technician.

• The plug for this unit is polarized with one blade wider than the other. Do not force the plug into an electrical outlet. Do not alter the plug in any way. If the plug does not fit into the outlet, reverse the plug. If it still does not fit, contact a qualified technician to install a proper outlet.

• Do not use if the power cord or plug is damaged or the connection to the wall outlet is loose.

• Use AC 120V only.

• Do not damage, break, forcefully bend, pull, twist, bundle, coat, pinch, or place heavy objects on the power cord.

• Periodically remove dust from the power plug.

This will reduce the risk of shock due to humidity build up.

• Remove the power plug from the outlet before cleaning the unit. When removing the power plug, grasp by holding the plug itself, never hold by the cord.

• If the power plug is damaged, it must be replaced by the manufacturer or a qualified technician.

•

•

Remove the power plug from the outlet when not in use.

Do not handle the power plug with wet hands.

• Do not operate the unit when using indoor smoke-generating insecticides.

• Do not clean unit with benzene or paint thinner.

Do not spray insecticides on the unit.

• Do not use the unit where it is humid or where the unit may become wet, such as the bathroom.

• Do not insert fingers or foreign objects into air intake or outlet.

• Do not use the unit near flammable gases. Do not use near cigarettes, incense, or other sparkcreating items.

• Unit will not remove carbon monoxide emitted from heating appliances or other sources.

• Unplugging the product disconnects the remote functions.

IMPORTANT PRECAUTIONS FOR USING YOUR AIR PURIFIER:

• Do not block the intake or outlet vents.

• Do not operate without a filter.

• Do not use near hot objects, such as a stove.

• Do not use where the unit may come into contact with steam.

• Do not wash and reuse the True HEPA Filter.

• Hold the handle on the back of the unit to transport.

• Do not use the unit on its side.

• Keep away from products that generate oily residue, such as a deep fryer.

• Do not use detergent to clean the unit.

• Do not hold by the front panel.

• Do not stick any small objects into the air outlet vents or fan.

TWO YEARS WARRANTY

The terms of the warranty are as follows:

1. This product is manufactured under stringent quality control and inspections.

2. The warranty will be voided if product failure is a result of negligence or misuse by the consumer.

3. A proof of purchase must be presented upon claiming a Product Warranty.

4. Store the proof of purchase in a safe place or register your product on winixamerica.

com to upload your proof of purchase.

5. This warranty is valid only in the USA and

Canada.

* for more information visit https:// winixamerica.com/terms-and-conditions/

Product Name

Model Name

Purchase Date

Warranty Period

Place of Purchase

Place of Purchase tel.

Customer

Address

Name

Tel.

Air Purifier

XLC

Two (2) Years

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,

Science and Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two conditions:

• This device may not cause interference.

• This device must accept any interference, including interference that may cause undesired operation of the device.

"In French: Cet appareil contient des émetteurs/récepteurs exemptés de licence et conformes aux normes Innovation, Science et Economic. RSS(s) sans licence de Développement Canada. Le fonctionnement est soumis aux deux conditions suivantes:

• cet appareil ne doit pas causer d’interférences nuisibles, et

• cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant provoquer un fonctionnement non souhaité."

2610-0324-00 Rev.00

AIR PURIFIER

XLC USER MANUAL

• The product warranty is printed on the back of this guide.

This product is manufactured for use only in USA / CA. This product is suitable for 120V only.

The energy efficiency of this ENERGY STAR certified model is measured based on a ratio between the model’s

CADR for smoke and the electrical energy it consumes, or CADR/Watt.