Schlage Galaxy 635 AD400 NDE LE RS485 Wiring Diagram

AC
INPUT
AC
INPUT
2x18
IP/PoE
NDE
LOCK
UL294
12/24VDC
POWER
SUPPLY
+
-
GWE
GATEWAY
LE
LOCK
RS485 4000' MAX
AC
INPUT
+
PIM400-485
AD400
LOCK
2x18
P5
RDA-
PIM400485-V2
12/24VDC
POWER
SUPPLY
GND
120
VAC
WIRING SHOWN REFLECTS WIRING TO SCHLAGE PIM-485 AND GWE FROM GALAXY 635 ONLY. ADDITIONAL WIRING WILL BE REQUIRED ON THE GALAXY 635 AND WILL NOT BE SHOWN HERE.
EARTH GROUND SHIELD ON BELDEN 3106A CABLE AT GALAXY 635 CONTROLLER ENCLOSURE ONLY.
TITLE:
120VAC
82417-2 GALAXY
DWG NO:
BRENDA DOVE 08/24/17
DRAWN/CHECKED BY:
111881
GALAXY 635 CONTROLLER
PIM400-485/AD400 AND GWE/LE
TX
GND
GND
RX
GND
B
A
PWR
GALAXY 635
DSI MODULE
GND
B
A
PWR
DSI DUAL SERIAL INTERFACE
GALAXY 635 CONTROLLER
RS485 TERMINATION IS NOT TYPICALLY REQUIRED. IF YOU ARE EXPERIENCING INTERMITTENT OR ERRATIC COMMUNICATION PROBLEMS, INSTALL A 120 ohm RESISTOR AT THE BEGINNING AND AT THE
END OF THE RS485 DATA LINE PARALLELED ACROSS DATA LINES. NOTE, INCORRECTLY INSTALLED TERMINATION RESISTORS CAN CREATE MORE PROBLEMS AND SHOULD ONLY BE USED OF REQUIRED.
WITH HHD OR ENGAGE APP SET LO AND HI WAPM ID'S. BY DEFAULT, PIM AND GWE USES 0-15, MUST BE CHANGED TO 1-16. IF LO IS 0 THEY WILL NOT COMMUNICATE.
UL 294 POWER SUPPLIES USED SHOULD NOT BOND EARTH GROUND TO SIGNAL GROUND.
IF PLENUM RATED CABLE IS REQUIRED USE BELDEN 82842 OR EQUIVALENT.
GND
GND
TDA-
BELDEN 3106A
NEU
LINE
UL 294
12/24VDC
SUPPLY
SHIELD
BLU/WHT
WHT/ORG
ORG/WHT
RDB+
TDB+
A PIM400-485 WILL SUPPORT UP TO SIXTEEN AD400 OR WRI400 OR WPR400 OR WSM400 TOTAL. GWE CAN SUPPORT UP TO 10 NDE OR LE LOCKS COMBINED.
NOTE: CONFIGURATION HAS BEEN TESTED IN ALLEGION LABS AND HAS BEEN REVIEWED AND APPROVED BY GALAXY.
12VDC
NEU
GND
LINE
UL 294
12/24VDC
SUPPLY
GND
TX+
RX+
TXRX-
MAX SIXTY-FOUR AD400 OR NDE/LE PER GALAXY 635 CPU. EACH DSI BOARD HAS TWO RS485 PORTS EACH SUPPORTING UP TO SIXTEEN AD, NDE, LE LOCKS COMBINED.
+
-
REV
B