advertisement
Ground Fixed
Harmony Bells
Page 1 of 4
Metric Conversion:
400mm/ 16”
1650mm/ 64 61/64”
1.5m/ 59” x2 x2 x2
Installation Instructions
1. Lay packaging out on floor and clear workspace with non-abrasive surface for assembly to prevent marking of polished stainless steel.
2. Unpack ground fixing extensions.
3. Cluster extensions together with M10 tapped holes facing outward and ground fixing holes aligned
(See Page 3). Insert
M10x200mm threaded bars into ground fixing holes and secure loosely with M10 BZP nuts.
4. Unpack Bell Flowers and posts.
5. Screw Bell Flowers on to their respective posts (See
Page 2).
Weight of heaviest part 8Kg (Large Bell) x3
6. Sleave each post over an extension (clustered) and secure with an M10x40
Screw. Ensure their orientation and configuration is correct before tightening.
7. Excavate a hole for the frame 250mm diameter, tapering down to 350mm,
450 deep in desired location upon decision from customer.
2. Fill bottom 50mm of hole with compressed aggregate.
9. Locate (lower) frame into hole making sure that the flowers are level and upright.
Do not bury the bolt and barrel nut holes.
10. Once happy with location of the Bells, fill hole using rapid hardening concrete. Be sure to compact concrete around legs and leave to dry according to manufactures guidelines.
Ground Surface
Ground Fix
Components: x3
M10x200 Threaded bar x6
M10 BZP Nut
BS EN 1176
Small
Beaters X3
1.5m
1650mm
1.5m
Install
Instrument with 1.5m free space (from widest point) around it.
CAUTION: Frame surface can get hot in direct sunlight, if possible install in shaded areas.
400mm
Spares available from percussionplay.com or from your local distributor
24 Kg
Ground Fixed
Harmony Bells
Page 2 of 4
Installation Instructions
Remove nylon nut and 40mm spacer to expose threadlocker, and screw bell into post.
Components:
Saddle Straps x3 x6
M6x20 Security Screw
*Bell Flowers arrive pre-assembled.
Small
Beaters X3
BS EN 1176
Spares available from percussionplay.com or from your local distributor
24 Kg
Ground Fixed
Harmony Bells
Page 3 of 4
Assembly Guide PPHARMB
1.
2.
Components: x3
M10x30mm Pin Torx
3.
Tools: x1
TX 45 Driver Bit
BS EN 1176
Small
Beaters X3
Ground Fix
Components: x3
M10x200 Threaded bar x6
M10 BZP Nut
Spares available from percussionplay.com or from your local distributor
24 Kg
Ground Fixed
Harmony Bells
Page 4 of 4
Ground Fix Installation
1.
(1.1)
Components: x3
M10x200 Threaded Bar x6
M10 BZP Nut
Metric Conversion:
50mm/ 2”
250mm/ 10”
350mm/ 14”
400mm/ 16”
450mm/ 18”
BS EN 1176
2.
3.
Foundations should not present a hazard. These foundations are recommended as a guide, for more information on foundation details for various surface see Part 1 of BS EN 1176.
advertisement