Frame these instructions and mount on the wall next to the control panel.
Edwards Signaling Fire Alarm Control Panel Operating Instructions
For models: E-FSA64G, E-FSA64GD, E-FSA64R, E-FSA64RD,
E-FSA250G, E-FSA250GD, E-FSA250R, E-FSA250RD
For additional information, refer to the
Edwards Signaling
eFSA64 and eFSA250 Technical Reference Manual (P/N
3101202-EN).
TO SILENCE THE PANEL BUZZER
1. Press Panel Silence.
RESPONDING TO ALARM SIGNALS
1. Evacuate the area.
The buzzer turns off. Any new events turn the buzzer back on. Trouble conditions not cleared resound the buzzer after a predetermined time.
2. Notify the proper authorities immediately and state the nature and location of the emergency.
3. Be prepared to provide directions to firefighters when they arrive.
WARNING! Trouble conditions may affect the panel's ability to provide early detection and indication of a fire. Clear trouble conditions immediately.
RESPONDING TO SUPERVISORY SIGNALS
TO SILENCE ALARM NOTIFICATION SIGNALS
1. Silence the panel buzzer.
WARNING! Alarm notification signals should not be silenced until after all occupants have been evacuated.
1. Press Signal Silence.
2. Investigate the cause of the supervisory signal and notify the authorized service personnel immediately.
RESPONDING TO MONITOR SIGNALS
The Signal Silenced LED turns on and all audible notification circuits turn off. New alarm events turn the notification circuits back on.
Note: Panel programming may delay alarm silence for up to one minute, may prevent alarm silencing when water flows through the sprinkler system, and may not turn off visible notification circuits.
TO RETURN THE SYSTEM TO NORMAL AFTER AN
ALARM OR SUPERVISORY EVENT
1. Make sure all smoke detectors are free from smoke and all manual pull stations are reset.
1. Silence the panel buzzer.
2. Investigate the cause of the monitor signal and notify the authorized service personnel immediately.
PERIODIC TEST RECOMMENDATIONS
See “Maintenance and Testing,” in the
Edwards Signaling
eFSA64 and eFSA250 Technical Reference Manual for test instructions and references.
Installed by
Name:
Company:
Note: Panel programming may delay panel reset for up to one minute after alarm notification circuits turn on.
Address:
TO INITIATE A FIRE DRILL
1. Press the Menu button.
Phone:
Per NFPA 72
Protected Premises Fire Alarm System, Local
3. Enter your password (the minimum of a level one password is required).
Auxiliary Fire Alarm System
Remote Supervising Station Fire Alarm System
All audible notification circuits turn on. This function will not automatically notify the fire department.
TO PERFORM A LAMP TEST (panel and remote annunciators)
1. Press Lamp Test.
TO PERFORM A REMOTE ANNUNCIATOR LAMP TEST
1. Press and hold the Silence button on the LCRA for five seconds.
2. LEDs on remote annunciators will remain on until silence button is released.
RESPONDING TO TROUBLE SIGNALS
1. Silence the panel buzzer.
2. Investigate the cause of the trouble and notify the authorized service personnel immediately.
Date:
For service contact
Company:
Address:
Phone:
Acceptance Inspection by
Date:
© 2011 UTC Fire & Security. All rights reserved. 1 / 1 P/N 3101201-EN • REV 2.0 • ISS 14APR11
