Walmart EverStart manual

Walmart EverStart is a multi-function jump starter that can quickly and easily start your vehicle in an emergency. It also features a USB output port to charge your electronic devices and a built-in LED flashlight. With its compact size and portability, you can take it with you wherever you go. Ideal for small to mid-sized vehicles, it can help you get back on the road in no time.

PDF
Document
Walmart EverStart Jump Starter Manual | Manualzz

Advertisement

Advertisement

MULTI-FUNCTION JUMP STARTER
FEATURES
1. Flashlight
2. Jump Start Port
3. LED Power indicator
4. USB Output
5. Power button
6. Charging port
7. Car battery clamp
8. Home charger&Car charger
9. Portable bag
IMPORTANT SAFETY INSTRUCTIONS
RED ALL INSTRUCTIONS
WARNING: Read all instructions before operating the jump starter. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious injury.
WARNINGS AND INSTRUCTIONS
WARNING:
Avoid dangerous environments. Don’t use appliances in damp or wet locations. Don’t use
appliances in the rain.
Keep children away. All visitors should be kept at a distance from work area.
Store idle appliance indoors. When not in use, appliances should be stored indoors in dry,
and high or locked-up place-out of reach of children.
Never carry appliance by cord or yank it to disconnect receptacle. Keep cord away from heat,
oil, sharp edges and other abuse.
Disconnect the appliance from the power supply when not in use, before servicing, and when
changing accessories.
Use of accessories and attachments. The use of any accessory or attachment not
recommended for use with this appliance could be hazardous.
Stay alert, and do not operate appliance if you are tired or impaired.
Do not operate this appliance near flammable liquids or in gaseous or explosive
atmospheres.
Never submerge this unit or the AC charging adapter in water; do not expose this unit or the
AC charging adapter to rain, snow or use when wet.
To reduce risk of electric shock. Disconnect the unit from any power source before cleaning.
Turning off controls without disconnecting will not reduce this risk.
SAFETY INSTRUCTIONS FOR CHARGING THIS UNIT
IMPORTANT: This unit is delivered in a partially charged state. Fully charge the unit with the
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not approved by the party responsible for compliance could void
user’s authority to operate the equipment.
supplied AC charging adapter for a full 6 hours(or until the unit shows as fully charged)before
using for the first time.
The recommended method for recharging this unit is using the AC charging adapter. When
using this method, only use the AC charging adapter supplied with the unit. Plug in the
charging adapter at the jump starter first, then plug into the charging source.
After charging/recharging, disconnect charging adapter and wait 5 minutes before use.
Do not crush, cut, pull or expose charging adapter cords to extreme heat.
Position charging adapter cords so they do not become entangled or become a safety
hazard. Keep charging adapter cords away from sharp edges.
Use in a dry location only.
Do not attempt to charge the unit if the charger is damaged.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: Disconnect
Adapter by pulling the plug rather than the cord when disconnecting the Charging Adapter.
SAFETY INSTRUCTIONS FOR LITHIUM BATTERIES
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, BURST HAZARD, OR
INJURY TO PERSONS OR PROPERTY:
Lithium batteries are small, compact and ideal for providing long-lasting power to this unit.
However, they must be used and charged properly. Improper use can result in serious injury, fire,
or death.
Lithium batteries can explode in the presence of a source of ignition. Do not use the product
in the presence of an open flame
Do not place this lithium battery powered unit in fire or apply heat to it
Do not subject this lithium battery powered unit to strong impacts or shocks. The battery in
this unit contains safety and protection devices which, if damaged, may cause the battery to
generate heat, rupture or ignite
Do not expose this lithium battery powered unit to water or salt water, or allow the battery to
get wet
Avoid storing this lithium battery powered unit in the basement, bathroom or other areas of
the house that are or may become wet or humid or where moisture may concentrate.
Do not leave this lithium battery powered unit in direct sunlight, or use or store the unit inside
cars in hot weather. Doing so may cause the battery to generate heat, rupture, or ignite.
Using the battery in this manner may also result in a loss of performance and a shortened life
expectancy.
Never charge this unit near heat or flammable objects.
NEVER THROW WATER ON A BURNING LITHIUM BATTERY! If a lithium battery does
catch on fire, it will burn even more violently if it comes in contact with water or even
moisture in the air. A Class D fire extinguisher must be used.
Battery Charging and Capacity
This unit is delivered in a partially charged state. You should charge it for 4-6 hours before
first use.
When stored at room temperature with a full charge, Lithium batteries will begin to discharge from
the time they are manufactured, even when unused. Deep discharges also decrease their
capacity. Battery life can be extended by the following:
Charge battery to full capacity before storage
Ideal storage temperatures for this unit range between 41°F and 68°F (5°C and 20°C).
Never discharge the battery fully.
Charge after each use.
Always charge at least every 3-6 months to prevent over discharge.
Transportation of Lithium-Ion Batteries
Always check all applicable local, national, and international regulations before transporting
a unit containing a lithium-ion battery.
Transporting an end-of-life, damaged, or recalled battery may, in certain cases, be
specifically limited or prohibited.
SAFETY INSTRUCTIONS FOR JUMP STARTER
WARNING: RISK OF EXPLOSIVE GASES
Working in the vicinity of a lead acid battery is dangerous. Batteries generate explosive
gases during normal battery operation. For this reason, it is of the utmost importance that
each time before using the jump-starter you read this manual and follow instructions
exactly.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
NEVER ATTEMPT TO BOOST OR CHARGE A FROZEN BATTERY.
When working with lead acid batteries, always make sure immediate assistance is available
in case of accident or emergency.
Never smoke or allow a spark or flame in vicinity of vehicle battery, engine or jump starter.
Remove personal metal items such as rings, bracelets, necklaces and watches when
working with a lead acid battery. A lead acid battery can produce a short circuit current high
enough to weld a ring, or similar metal object, to skin, causing a severe burn.
Do not operate unit with damaged cord or plug; or if the unit has received a sharp blow, been
dropped, or otherwise damaged in any way. Do not disassemble the unit, opening the unit
may result in a risk of electric shock or fire.
Do not leave the unit unattended while in use.
This unit is not for use by children or infirm persons.
Disconnect adapter by pulling the plug rather than the cord when disconnecting the AC
charging adapter.
SAVE THESE INSTRUCTIONS
INTRODUCTION
Congratulations on purchasing your new Lithium battery jump starter. Read this
instruction manual and follow the instructions carefully before using this unit.
IMPORTANT Notes:
The jump starter is designed for use on small to mid-sized vehicle batteries( 6 cylinder or
smaller).
Several factors can affect the jump starter’s ability start the vehicle, including, but not limited
to the size of the vehicle battery, the temperature(hot or cold), whether the battery is
damaged or defective, and whether the jump starter itself has sufficient power.
Before starting the vehicle, be sure all vehicle accessories(i.e. Heater, fan, radio, TV,
lights,etc.) are turned off.
POWER STATUS INDICATOR LIGHTS
Before using the unit, checking the power status whether itself has sufficient power.
Press the power button, the LED power indicator turn light. Refer to below features:
/

Advertisement

Key features

  • Jump start port for reviving dead car batteries

  • LED flashlight for illumination in low-visibility situations

  • USB output port for charging electronic devices

  • Compact and portable design with carrying bag for easy storage and transport

  • Built-in LED power indicator for monitoring battery level

Frequently asked questions

Refer to the safety instructions section of the manual for important safety guidelines.

Charge for 4-6 hours before first use.

The manual does not specify whether the USB output supports charging laptops.

User questions

E F

Patricia E.

How do I prepare the WM1510MA charger for its first use?

No votes

Fully charge the unit with the supplied AC charging adapter for a full 6 hours or until the unit shows as fully charged. Disconnect the charging adapter and wait for 5 minutes before using the jump starter.

V R

Jennifer V.

How do I determine the battery level of the jump starter?

No votes

Press the power button to check the LED power indicator lights. The LEDs will light up according to the battery level: 2 red LEDs (25%), 4 red LEDs (50%), 4 red LEDs + 2 blue LEDs (75%).

V R

Jennifer V.

How do I charge the jump starter?

No votes

Connect the AC charging adapter to the jump starter and then plug it into the charging source. Charge for a full 6 hours before first use.

E F

Patricia E.

Are there any specific precautions I should take when handling the charging adapter cords?

No votes

Do not crush, cut, pull, or expose the charging adapter cords to extreme heat. Position the cords so that they do not become entangled or pose a safety hazard.

Preparing document for printing…
0%