AS73210-AS89010-C3 SET DK
Development Kit with USB interface
6.7 Spectrometer
These features are optional and active if the startup parameter was set (see chapter 6.1) and a
sensor C3 and a spectrometer
7
work parallel. In following the functions, parameters and windows
used for the spectrometers from JETI Specbos 1201/1211 are described. For further technical details of the spectrometer please check the individual description of the device.
Within the “
Spectrometer
section”, specific parameters and options for the parallel usage of the spectrometer and sensors can be set.
Figure 11: Spectrometer settings
Spect off/on:
Turn the spectrometer on/off.
Note:
In case of the spectrometer will be switched on, the numbers measurements for sensor devices will be reset.
Laser on/off:
Activates the laser spot to focus the spectrometer onto a target. Activated a laser circle indicates the measurement zone.
Set:
The configuration will be send to the spectrometer. These values will be used for the next measurement.
Wavelength start/end:
Defines the range to detect the spectral data of the source to be measured.
The visible spectrum is in range between 380 nm and 780 nm. Other devices with an extended range can also be used.
Integration time:
Configures the time to measure an object. The default value is set to 0 and is highly recommended to use.
Average:
The amount of measurements that are performed to receive the spectral information about a source or an object.
ams User Guide
[v1-00] 2017-Jul-11
Page 17
Document Feedback
