MAINTENANCE
1.
Press top of locking tabs (A) on both sides of Speed Feed
® head to release cover (B) from eyelet carrier (C).
2.
Remove cover from eyelet carrier.
C
Nylon Line Replacement
Wear gloves or personal injury may result:
◆
Cutoff knife is sharp.
◆
Gearcase and surrounding area may be hot.
1.
Cut one piece of line to recommended length.
2.0 mm (0.080 in.) diameter
7.6 m (25 ft.).
2.4 mm (0.095 in.) diameter
7.6 m (25 ft.).
2.
Align arrows on top of knob with openings in eyelets.
B
A
SRM-3020
3.
Insert one end of trimmer line into an eyelet, and push line equal distance through trimmer head.
40
X7502350002
©
2/20
ECHO Incorporated
SRM-3020
4.
Hold trimmer head while turning knob clockwise to wind line onto spool until about
13 cm (5 in.) of each line remains exposed.
Trimmer head is now fully loaded and ready for operation.
MAINTENANCE
When the wear indicators located at the bottom of the
Speed-Feed
®
head are worn smooth, or if holes appear, replacement of the cover or the entire Speed-Feed
®
head is required.
HDFH line head requires no maintenance.
X7502350002
©
2/20
ECHO Incorporated
41
