OPERATION
Stopping Engine
1.
Throttle
Release throttle trigger and allow engine to return to idle before shutting off engine.
2.
Stop Switch
Move stop switch button (A) backward to STOP position.
A
A
SRM-3020T
If engine does not stop when stop switch is moved to STOP position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using unit again.
Applications
Nylon line heads may be used for trimming, scything, edging, and scalping of grass and light weeds
Trimming
Feed the spinning line into the material to be cut. Tilt the line head to one side to direct cutting debris away from you:
• Model SRM/PAS/SB (Straight shaft, counter-clockwise line head rotation)
- Tilt the cutting head down on the right side (muffler side) while cutting to direct cutting debris away from operator. Feed the line gradually into the material you wish to cut, avoiding contact with fences or other barriers
Scything
Scything - Swing the cutting head in a level arc, gradually feeding the line into the material being cut. Move forward with each arc to cut a swath. Width of cutting swath depends on arc. Use a larger arc for a wider swath, or a smaller arc for a narrow swath. Keep line head tilted to direct cutting debris forward or away from you.
Operating Techniques
• Debris flows in direction of lne head rotation. Change line head position to assure debris flow is directed away from operator.
28
X7502350102
©
2/20
ECHO Incorporated
