SRM-3020T
MAINTENANCE
COMPONENT/SYSTEM
Fuel Filter
Fuel Cap Gasket
MAINTENANCE
PROCEDURE
Inspect/Replace *
Replace *
SKILL
LEVEL
1
IMPORTANT NOTE
- Time intervals shown are maximum. Actual use and your experience will determine the frequency of required maintenance.
MAINTENANCE PROCEDURE NOTES:
1 Apply lithium based grease every 25 hours of use.
2 Apply lithium based grease every 50 hours of use.
3 Low evaporative fuel tanks DO NOT require regular maintenance to maintain emission integrity.
* Replacement is recommended based on the finding of damage or wear during inspection.
Air Filter
Level 1
Parts Required: Tune Up Kit.
1.
Close choke (COLD START position). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from air cleaner area.
2.
Remove air filter cover. Brush dirt from inside cover.
Assure throttle wire retaining clip
(A) remains in place as shown when removing or installing air filter cover.
A
B
D
E
C
A
X7502350102
©
2/20
ECHO Incorporated
33
