2.6.2.5 Entering Character Data. Magnetrol Pulsar R96 HART

24

2.6.2.5 Entering Character Data

This method is used for parameters requiring alphanumeric character entry, such as for entering tags, etc.

General Menu Notes:

Push button

Up

Down

Back

Enter

Keystroke Action

Moves to the previous character (Z...Y...X...W).

If held down, the characters scroll until the push button is released.

Moves to the next item character (A...B...C...D).

If held down, the characters scroll until the push button is released.

Moves the cursor back to the left. If the cursor is already at the leftmost position, then the screen is exited without changing the original tag characters.

Moves the cursor forward to the right. If the cursor is at the rightmost position, then the new tag is saved.

2.6.3 Password Protection

The PULSAR Model R96 transmitter has three levels of password protection to restrict access to certain portions of the menu structure that affect the operation of the system.

The user password can be changed to any numerical value up to 59999. When the transmitter is programmed for password protection, a password is required whenever configuration values are changed.

User Password

The User Password allows the customer to limit access to the basic configuration parameters.

The default User Password installed in the transmitter at the factory is 0. With a password of 0, the transmitter is no longer password protected and any value in the basic user menus can be adjusted without entering a confirming password.

NOTE: If a User Password is not known or has been misplaced, the menu item New Password in the DEVICE SETUP/ADVANCED

CONFIG menu displays an encrypted value representing the present password. Contact Technical Support with this encrypted password to retrieve the original User Password.

58-602 Pulsar

®

Model R96 Radar Transmitter