Installation Requirements. Whirlpool KUBR204ESB01, KUBL204ESB00, KUBR304EBS00, KUBR204EPA01, KUBR304ESS01, KUBL204EPA01, KUBL304EBS00, KUBR304ESS00, KUBR204ESB00, KUBL304ESS00

■

INSTALLATION REQUIREMENTS

■

If the floor of the opening is not level with the kitchen floor, shim the opening to make it level with the kitchen floor.

Tools

Tool Needed

Gather the required tool before starting installation.

Phillips screwdriver

14

³⁄₄

"

(37.5 cm)

Location Requirements

WARNING

A

34

³⁄₈

" (87.3 cm) min.

35" (88.9 cm) max.

¹⁄₂

"

(1.3 cm)

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from beverage center.

Failure to do so can result in death, explosion, or fire.

To ensure proper ventilation for your beverage center, allow for a

¹

/

₄

" (6.35 mm) space on each side and at the top. When installing your beverage center next to a fixed wall, leave 2

¹⁄₂

" (6.35 cm) minimum clearance on the hinge side to allow for the door to swing open.

NOTE: It is recommended that you do not install the beverage center near an oven, radiator, or other heat source. Do not install in a location where the temperature will fall below 55°F (13°C). For best performance, do not install the beverage center behind a cabinet door or block the base grille.

24"

(60.96 cm) min.

B

24" (60.96 cm) min.

Critical Dimensions:

A. 14

³⁄₄

" (37.5 cm) utility opening

B. 24" (60.96 cm) minimum opening width

Electrical Requirements

WARNING

¹⁄₄

" (6.35 mm)

2

¹⁄₂

" (6.35 cm)

Opening Dimensions

■

Height dimensions are shown with the leveling legs extended to the minimum height.

NOTE: When leveling legs are fully extended, add

⁵⁄₈

" (15 mm) to the height dimensions.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Before you move your beverage center into its final location, it is important to make sure you have the proper electrical connection.

Recommended Grounding Method

A 115 volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your beverage center be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, unplug beverage center or disconnect power.

4