Installing the front adapter-retention bracket. IBM IntelliStation Z Pro 9232, IntelliStation Z Pro Type 9228, 9228 - IntelliStation Z - Pro

4. Remove any full-length adapters that are installed (see “Removing an adapter” on page 36).

5. Press the blue dot on the bottom retention tab of the front adapter-retention bracket; then, rotate the retention bracket to a 45 degree angle. This tab is located inside the fan compartment that is next to the front adapter-retention bracket.

6. Push the top and bottom sides of the adapter-retention bracket out of the notches that secure the retention bracket to the chassis, (see Figure 43).

Remove the retention bracket from the chassis.

7. If you are instructed to return the adapter-retention bracket, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Installing the front adapter-retention bracket

To install the front adapter-retention bracket, complete the following steps.

Release tab

Pivot points

Rear view

Front view

Figure 44. Installing the front adapter-retention bracket

1. Engage the top and bottom sides of the front adapter-retention bracket with the front adapter-retention bracket openings in the chassis (see Figure 44).

IBM IntelliStation Z Pro Type 9228 and 9232: Problem Determination and Service Guide