- Home
- Domestic appliances
- Large home appliances
- High-pressure cleaners
- Campbell Hausfeld
- PW167600AV
- User manual
Setup, Operating and Maintenance Instructions. Campbell Hausfeld CAMPBELL PW167600AV, PW167600AV
Add to my manuals
24 Pages
advertisement
Electric High Pressure Washer
Setup and Operating
Instructions
THINGS TO REMEMBER
1. Always check the inlet filter for debris.
2. Always reset the Ground Circuit
Interrupter (GFCI) each time the unit is plugged into an outlet.
3. Never direct a single point spray at a soft or breakable surface.
5. Plug the power cord into a grounded outlet and press the reset button on the GFCI as shown in Figure 12.
THIS MUST BE DONE EACH TIME
THE UNIT IS PLUGGED INTO AN
OUTLET.
Reset
3. Slide nozzle to the low pressure position as shown in Figure 14 and apply detergent.
IMPORTANT: Unit will only apply detergent when adjustable nozzle is used and the nozzle is in the low pressure position.
LOW PRESSURE
GARDEN HOSE CONNECTION
INSTRUCTIONS
1. Attach nipple adapter to inlet fitting on the unit.
2. Attach quick connect to garden hose.
3. Pull side “A” of quick connect toward garden hose and push onto nipple adapter.
4. Push side “A” of quick connect towards nipple adapter and release.
"A"
Figure 10
SYSTEM CONNECTION
1. Ensure that the power switch is in the OFF position.
2. Attach high pressure hose and gun assembly to the unit.
3. Insert lance into the gun and turn clockwise to positive stop as shown in Figure 11.
Figure 11
4. Connect garden hose as explained in the Garden Hose Connection
Instructions.
Figure 12
6. Turn the water on.
7. Trigger the gun for 1 minute to release pressure and to remove any air trapped in the system.
8. Turn the OFF/ON switch to the ON position.
The pressure washer is now ready to use on your cleaning application.
Please refer to Figure 13 for nozzle fan adjustment.
HIGH PRESSURE
Figure 14
4. To rinse or return to high pressure, release the trigger and slide the nozzle to the high pressure position.
NEVER SLIDE THE NOZZLE FROM
LOW TO HIGH OR HIGH TO LOW
PRESSURE WHEN THE GUN IS TRIG-
GERED.
Rotating the nozzle will vary the spray pattern from approximately a
0 o stream to a 60 o fan spray.
NOTE: The Turbo Lance is NOT adjustable and cannot be used to apply detergent.
Figure 13
DETERGENT APPLICATION
1. Remove the cap from the detergent tank and pour in UNDILUTED pressure washer detergent. Replace cap.
2. Turn the OFF/ON switch to the ON position.
Maintenance
1. Never store unit outdoors or where it could freeze.
2. LONG STORAGE PERIODS: When the unit is stored for more than 2 months, run a mixture of 50% antifreeze and water through the pump as follows:
--Remove the high pressure hose and garden hose from the pump.
--Tilt the unit on its side and turn the OFF/ON switch to the ON position.
--Pour 1 cup of the 50% antifreeze and water mixture into the inlet side of the pump.
--Turn the unit OFF. It is now ready for storage.
4
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 2 Specifications
- 3 Installation Instructions
- 4 Setup, Operating and Maintenance Instructions
- 5 Troubleshooting Chart
- 6 Replacement Parts List
- 7 Warranty
- 10 Spécifications
- 11 Information de Sécurité et Avertissements
- 11 Instructions d’Installation
- 12 Instructions de Montage, d’Opération et d’Entretien
- 13 Guide de Dépannage
- 14 Liste de Pièces de Rechange
- 15 Garantie
- 18 Especificaciones
- 20 Instrucciones para la Instalación
- 21 Instrucciones para conectar, operar y darle mantenimiento
- 21 Guía de Diagnóstico de Averías
- 22 Lista de Repuestos
- 23 Garantía