Using RAID 1 mode. Buffalo Technology TSXE80TLR5, TS-RXL, HD-HGLAN Series
Add to My manuals157 Pages
advertisement
Using RAID 1 mode
1
Change system to normal mode (page 20).
2 Click [System] - [Storage] - [RAID Array] in the Web Admin interface.
3
4
Click the array you want to set.
Click hard disks (Disk 1 and Disk 2, or Disk 3 and Disk 4) in RAID1.
5 1 Select [RAID 1].
2 Click [Create Raid Array].
Note:
After the RAID array is changed, the TeraStation will perfom a RAID check that will take about 5 hours per TB. File transfers will be slower during this period. While the “RAID ARRAY x Resyncing” message is displayed on the LCD screen, do not turn off the TeraStation. If you turn it off, the RAID check will start over.
6
The [Confirm Operation] screen will appear. Enter the number shown in the [Confirmation Number] field within
60 seconds, and click [Apply].
7
Follow the instructions displayed on the screen.
You have set up a RAID 1 array. Repeat the steps to create a second RAID 1 array with the other two drives, or refer to page 26 to configure a hot spare with one of the remaining drives. Turn to page 43 to create a shared folder.
TeraStation User Manual 24
advertisement
Key Features
- Up to 16TB of storage
- Fast performance with read speeds of up to 110MB/s and write speeds of up to 100MB/s
- RAID 5 and 6 data protection
- Easy to set up and use with a user-friendly web interface
Related manuals
Frequently Answers and Questions
What is the maximum storage capacity of the Buffalo HD-HGLAN Series?
What is the read speed of the Buffalo HD-HGLAN Series?
What data protection features does the Buffalo HD-HGLAN Series offer?
advertisement