advertisement
Chapter 6
REMOTE CONTROL
The heat setting, the room temperature, and automatic start/stop of the stove can be remote controlled.
S = Luminous warning light that indicates which keys have been pressed.
Correspondence of display keys with remote control keys
1 = p3+p5
2 = p2
3 = p3
4 = p4
5 = p5
S
P2
P3
P5
P4 fi gure 6.1
To light the stove, press buttons 3 and 5 at the same time and hold for three seconds (Fig. 21); the stove automatically enters the lighting stage. This is followed by the start-up phase, which allows the stove to develop and settle the fl ame. When the lighting stage is complete, the stove goes into normal operation.
The heat setting can be adjusted using the buttons 5 and 4, and the room temperature setting can be adjusted using buttons 2 and 3.
To switch off the stove, press buttons 3 and 5 at the same time and hold for three seconds. Display D1 will show the message “OFF”.
The remote control operates with an MN21 12V battery (the kind used for gate openers).
To replace the batteries, open the cover in the rear part as illustrated below.
fi gure 6.2
Open by pressing the part circled in the fi gure
REMOTE CONTROL fi gure 6.3
21
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 7 WARNINGS AND SAFETY DEVICES
- 8 WHAT ARE PELLETS?
- 8 PELLET STORAGE
- 8 PELLET LOAD
- 9 SAFETY DEVICES
- 9 WARM AIR BLOWER BREAKDOWN
- 9 FUME EXHAUSTER BREAKDOWN
- 9 PELLET FEED MOTOR BREAKDOWN
- 9 IGNITION FAILURE
- 9 TEMPORARY POWER FAILURE
- 9 ELECTRICAL SAFETY
- 9 EXHAUST FUME SAFETY
- 9 PELLET OVERHEATING SAFETY
- 10 ASSEMBLY AND INSTALLATION INSTRUCTIONS
- 10 GLOSSARY
- 11 INSTALLATION
- 11 ADMISSIBLE INSTALLATIONS
- 11 PROHIBITED INSTALLATIONS
- 12 CONNECTION TO THE EXHAUST VENTING SYSTEM
- 12 EXHAUST CHANNEL OR PIPE
- 13 CHIMNEY OR SINGLE FLUE
- 15 CONNECTION TO THE FLUE AND COMBUSTION PRODUCT EXHAUST VENTING
- 15 CHIMNEY CAP
- 16 CONNECTION TO EXTERNAL AIR INTAKES
- 16 INSULATION, TRIMS, FACINGS, AND SAFETY PRECAUTIONS
- 16 NATIONAL, REGIONAL, PROVINCIAL AND MUNICIPAL LAWS
- 17 PRODUCT FUNCTIONALITY
- 17 CONTROL BOARD
- 17 LANGUAGE SELECTION
- 18 CURRENT DATE AND TIME ADJUSTMENT
- 18 BASIC INSTRUCTIONS
- 19 IGNITION
- 19 STOVE FUNCTIONING
- 19 NORMAL FUNCTIONING
- 20 SWITCH-OFF
- 21 REMOTE CONTROL
- 22 ROOM THERMOSTAT
- 22 DIGITAL THERMOSTAT (AS PER STANDARD)
- 22 MECHANICAL THERMOSTAT (OPTIONAL)
- 22 MECHANICAL THERMOSTAT INSTALLATION (OPTIONAL)
- 22 MECHANICAL THERMOSTAT FUNCTIONING
- 23 ACTUATOR)
- 24 USER PARAMETERS
- 24 OVEN FUNCTIONING MODES
- 25 NORMAL FUNCTIONING (NO TIMER)
- 25 TIMED FUNCTIONING (WITH TIMER)
- 26 NORMAL FUNCTIONING (NO TIMER)
- 26 TIMED FUNCTIONING (WITH TIMER)
- 26 WEEKLY PROGRAMMER
- 29 DAY-NIGHT TEMPERATURE FUNCTION
- 30 PELLET FEED ADJUSTMENT
- 32 CLEANING
- 33 CONNECTION TO THE FLUE
- 34 POT DIVIDER
- 35 PRODUCT DISPLAY TABLES
- 39 WARRANT