- Home
- Domestic appliances
- Large home appliances
- Water heaters & boilers
- Baxi
- MainEco System
- User manual
advertisement
![Recommendations. Baxi MainEco System, MainEco Combi 35, MainEco Combi | Manualzz Recommendations. Baxi MainEco System, MainEco Combi 35, MainEco Combi | Manualzz](http://s1.manualzz.com/store/data/001177548_1-249eea1db186af10a8bbd19a4d7d1c88-360x466.png)
2. Safety instructions and recommendations
2.2
Recommendations
Baxi MainEco Combi and System 24 - 28 - 35 / 18 -24
WARNING
Only qualified professionals are authorised to work on the appliance and the installation.
4
Regularly check the water pressure in the installation (minimum pressure 0.8 bar, recommended pressure between 1 and 2 bar).
4
Keep the appliance accessible at all times.
4
Never remove or cover labels and rating plates affixed to the appliance. Labels and rating plates must be legible throughout the entire lifetime of the appliance.
4
The appliance should be on Summer or Antrifreeze mode rather than switched off to guarantee the following functions:
Anti blocking of pumps
Antifreeze protection
2.2.1.
Benchmark Commissioning Checklist
Please ensure that the installer has fully completed the Benchmark
Checklist on the inside back pages of the installation instructions supplied with the product and that you have signed it to say that you have received a full and clear explanation of its operation. The installer is legally required to complete a commissioning checklist as a means of complying with the appropriate Building Regulations
(England and Wales).
All installations must be notified, by the installer, to Local Area
Building Control either directly or through a Competent Persons
Scheme. A Building Regulations Compliance Certificate will then be issued to the customer who should, on receipt, write the Notification
Number on the Benchmark Checklist.
This product should be serviced annually to optimise its safety, efficiency and performance. The service engineer should complete the relevant section of the Benchmark Service Record in the
Installation & Service manual after each service.
The completed Benchmark Checklist & proof of annual servicing
(where applicable) will be required in the event of any warranty work.
8 02092014 - 7621607-02
advertisement
Related manuals
advertisement
Table of contents
- 6 Introduction
- 6 Symbols used
- 6 Abbreviations
- 7 General
- 7 Manufacturer’s liability
- 7 Installer’s liability
- 8 User’s liability
- 8 Certifications
- 9 Safety instructions and recommendations
- 9 Safety instructions
- 10 Recommendations
- 10 Benchmark Commissioning Checklist
- 11 Description
- 11 Operating principle
- 11 Gas/air setting
- 11 Combustion
- 11 Heating and domestic hot water production
- 12 Main parts
- 12 Clearances around the boiler
- 13 Control system
- 13 Adjustment
- 13 Control panel
- 14 Operating the boiler
- 14 Commissioning the boiler
- 14 Reading the various current values
- 15 Installation shutdown
- 15 Antifreeze protection
- 16 Checking and maintenance
- 16 General instructions
- 16 Periodic checks
- 17 Filling the system
- 18 Bleeding the heating system
- 19 Draining the installation
- 20 Troubleshooting
- 20 Error codes
- 22 Incidents and solutions
- 23 Technical specifications
- 24 Energy savings
- 24 Energy-saving advice
- 24 Room thermostat and settings
- 25 Warranty
- 25 General
- 25 Warranty terms
- 25 Warranty registration, service & repair
- 25 Benchmark Commissioning Checklist
- 25 Ways to register your warranty
- 26 Annual service
- 27 Appendix
- 27 10.1 User instruction card