- Home
- Domestic appliances
- Large home appliances
- Water heaters & boilers
- Baxi
- MainEco System
- User manual
Checking and maintenance. Baxi MainEco System, MainEco Combi 35, MainEco Combi
Add to My manuals32 Pages
advertisement
5. Checking and maintenance Baxi MainEco Combi and System 24 - 28 - 35 / 18 -24
5 Checking and maintenance
5.1
General instructions
WARNING
4
Maintenance operations must be done by a qualified engineer.
4
An annual inspection is compulsory.
4
Only original spare parts must be used.
4
Carry out the inspection and standard maintenance operations once a year.
4 Carry out specific maintenance operations if necessary.
CAUTION
4
Maintenance operations must be done by a qualified engineer.
4
We recommend taking out a maintenance contract.
4 Only original spare parts must be used.
5.2
Periodic checks
4
Check the water pressure in the installation.
If the water pressure is lower than 0.8 bar, more water should be added. If necessary, top up the water level in the heating system (recommended hydraulic pressure between 1 and 2 bar).
¼See chapter: "Filling the system", page 15.
1
2
4
T000181-B
4
Carry out a visual check for the presence of any water leaks.
4 Open and close the radiator valves several times a year (this prevents the valves from seizing up).
4 Clean the outside of the boiler using a damp cloth and a light detergent.
CAUTION
Only a GasSafe Registered Installer is authorised to clean the inside of the boiler.
14 02092014 - 7621607-02
advertisement
Related manuals
advertisement
Table of contents
- 6 Introduction
- 6 Symbols used
- 6 Abbreviations
- 7 General
- 7 Manufacturer’s liability
- 7 Installer’s liability
- 8 User’s liability
- 8 Certifications
- 9 Safety instructions and recommendations
- 9 Safety instructions
- 10 Recommendations
- 10 Benchmark Commissioning Checklist
- 11 Description
- 11 Operating principle
- 11 Gas/air setting
- 11 Combustion
- 11 Heating and domestic hot water production
- 12 Main parts
- 12 Clearances around the boiler
- 13 Control system
- 13 Adjustment
- 13 Control panel
- 14 Operating the boiler
- 14 Commissioning the boiler
- 14 Reading the various current values
- 15 Installation shutdown
- 15 Antifreeze protection
- 16 Checking and maintenance
- 16 General instructions
- 16 Periodic checks
- 17 Filling the system
- 18 Bleeding the heating system
- 19 Draining the installation
- 20 Troubleshooting
- 20 Error codes
- 22 Incidents and solutions
- 23 Technical specifications
- 24 Energy savings
- 24 Energy-saving advice
- 24 Room thermostat and settings
- 25 Warranty
- 25 General
- 25 Warranty terms
- 25 Warranty registration, service & repair
- 25 Benchmark Commissioning Checklist
- 25 Ways to register your warranty
- 26 Annual service
- 27 Appendix
- 27 10.1 User instruction card