- Industrial & lab equipment
- Electrical equipment & supplies
- Power conditioning
- Power supply units
- MGE UPS Systems
- Pulsar Evolution 1500 Rack
- Installation And User Manual
Transfer to battery power. MGE UPS Systems Pulsar Evolution 1500 Rack, Pulsar Evolution 800 Rack, 1500, PULSAR ELLIPSE 800, Pulsar Evolution 1100 Rack, Pulsar Evolution 500 Rack, PULSAR ELLIPSE 500, Pulsar Evolution 1100, Pulsar Evolution 1500, Pulsar Evolution 800
Add to My manuals
65 Pages
advertisement
3. Operation
3.3 Operation on battery power (following failure of AC-input power)
Transfer to battery power
The AC-input power is out of tolerances, LED 11 goes ON.
During operation on battery power, the buzzer beeps every ten seconds.
The equipment connected to the UPS is supplied by the battery.
11
1 2
%
%
Threshold for the low-battery warning
%
1 2
%
11
When the threshold is reached, the buzzer beeps every three seconds.
The low-battery warning threshold can be set by the user, with the “UPS
Driver” software.
There is very little remaining battery backup time. Close all applications because UPS automatic shutdown is imminent.
When the battery reaches the end of its backup time, the UPS shuts down and all the LEDs go OFF.
The equipment is no longer supplied with power.
The UPS automatically restarts when power returns.
If the UPS does not restart, check that the “automatic restart when power returns” function has not been disabled (see section 3.4 Personalisation).
34007117EN/AB
- Page 19
advertisement
Related manuals
advertisement
Table of contents
- 8 Overall view
- 8 Tower models
- 8 Rack models
- 10 Control panel
- 11 Unpacking and parts check
- 11 Tower models
- 12 Rack models
- 13 Installation
- 13 Tower models
- 14 800/1100/1500 Rack models
- 15 500 Rack model
- 16 Connecting the protected equipment
- 18 Installation of the communications-card option
- 19 Start-up
- 20 Transfer to battery power
- 20 Threshold for the low-battery warning
- 21 Function
- 21 ON / OFF conditions tab
- 21 Battery tab
- 22 Voltage-thresholds tab
- 22 Sensitivity tab
- 40 Gesamtansicht
- 40 Tower- Modell
- 40 Rack- Modell
- 41 Rückansicht
- 42 Anzeige- und Bedienfeld
- 43 Entfernen der Verpackung und Überprüfung des Lieferumfangs
- 43 Tower- Modell
- 44 Rack- Modell
- 45 Aufstellung
- 45 Tower- Modell
- 46 Rack- Modell
- 48 Anschluß der Verbraucher
- 51 Inbetriebnahme
- 52 Umschaltung auf Batteriebetrieb
- 52 Voralarm "Ende der Autonomiezeit
- 53 Software, Installation und Funktion
- 53 Registerkarte "Ein/Aus-Bedingungen
- 53 Registerkarte "Batterie
- 54 Registerkarte "Spannungsgrenzwerte
- 54 Registerkarte "Ansprechempfindlichkeit