Crestron PMK-1000L Pre-Construction Wall Mount Kit
Pre-Construction Wall Mount Kit:
PMK-1000L
Description
The PMK-1000L is a pre-construction mount kit for the Crestron ® APAD LCD controller. The PMK-1000L is used for installation on a stud. For custom controller placement without a stud, use the TMK/WMKT-1000L or MMK/WMKM-1000L.
The PMK-1000L includes a 12-inch long, 18 AWG jumper wire to secure controller cabling prior to drywall installation and to avoid damaging the cables when the opening is routed. Refer to the physical views of the PMK-1000L shown on the following page. The table that follows lists all parts included with the PMK-1000L.
NOTE: This mounting kit is to be used only with the APAD LCD controller.
Supplied Hardware for the PMK-1000L
DESCRIPTION PART QUANTITY
Metal, Plate, Pre-Construction
Metal, Plate, Cover
Screw, #04-40 x 2”, Pan, Phil
Jumper wire, 12”, 18 AWG, Black
4505161
2004826
2018793
2007838
1
1
4
1
Installation Guide - DOC. 6061A Pre-Construction Mount Kit: PMK-1000L • 1
Pre-Construction Wall Mount Kit Crestron PMK-1000L
The dimensions of the PMK-1000L are shown below.
Dimensional Drawing
1.50 in
(3.81 cm)
1.00 in
(2.54 cm)
7.31 in
(18.57 cm) 3.74 in
(9.49 cm)
0.06 in
(0.16 cm)
5.77 in
(14.66 cm)
3.95 in
(10.02 cm)
#04-40 TAPPED HOLE IN
EACH CORNER
SECURE 18 AWG
JUMPER WIRE IN NOTCH
TO HANG CABLES AWAY
FROM CUTTING TOOLS
FOR
DRYWALL
NAILS OR
SCREWS
(NOT
INCLUDED)
7/16 in
(12 mm)
FOR DRYWALL SCREWS (NOT INCLUDED)
FOR DRYWALL NAILS (NOT INCLUDED)
4 3/8 in
(112 mm)
3 1/2 in
(89 mm)
1/2 in
(13 mm)
7/16 in
(12 mm) 1/16 in
(2 mm)
3 11/16 in
(94 mm)
4 3/8 in
(112 mm)
4 9/16 in
(116 mm)
Dimensional Drawing - Cover Plate
4.74 in
(12.03 cm) 0.03 in
(0.08 cm)
4.65 in
(11.82 cm)
2 • Pre-Construction Mount Kit: PMK-1000L Installation Guide - DOC. 6061A