Functional parts - Cooking setting control. Electrolux Floor-mounted stoves

4.2

Functional parts - Cooking setting control

4.2.1 Power controller

Fig. Power controller Fig. Switch in „OFF“ position

Input voltage 230 V

Fig. Performance characteristic

K1 – Knob position

% ED – Switching on period in percent

100 % corresponds to a switching on period of 41 seconds

The hot plates are controlled via the bimetallic contact P 1-2. The input voltage of 230 V is applied here.

Depending on the position of the knob, this contact determines how often the hot plate is switched on or off during a certain unit of time by cycling the maximum heating power (230 V or 0 V between contact 2 and 4) (refer to performance characteristic).

Continuous operation at max. heating power is hot plate 9.

The power characteristic shows the power controller in cycling mode.

The average switching on period for each knob position can be read off in % of the cycled and/or max. power.

DGS-TDS-N 05.09 A. B. © Electrolux - 20 599 527 691 EN

Dual circuit heating element

Dual circuit regulator

DGS-TDS-N 05.09 A. B. © Electrolux - 21 599 527 691 EN