10. ATTENTION POINT WITH SERVICE. Daewoo DWD-E6213, DWD-E1211W'S

10. ATTENTION POINT WITH SERVICING

No Item Part Name

1 Replacing Thermistor Thermistor Dry

Dry

2 Replacing Duct B As DUCT B AS &

& Duct Pipe DUCT PIPE

3 Replacing &

Repairing Inlet Valve

Inlet Valve

4 Replacing Hose Drain Hose Drain

5 Replacing HOSE

A,B,C

6 Replacing

Heater Wash

7 Replacing

“Thermistor Wash”

“Hinge Door”

HOSE A,B,C

Heater Wash

Checking Point

Keep the Packing from seperating (Hold Packing when replacing)

Keep the Packing from folding

Check the sealing between Duct Pipe & Duct B AS

Use only screw M4*8 for fixing Inlet Valve

Keep the sealing condition of Tub O tightly

Check the assembling order between INLET BOX & Hose A,C :

Pre Wash-Cold

Unfastening the nut for fixing earth first then unfasten the nut for fixing heater

At assembling the heater dry, check if the assembling condition between fixture heater is tight.(little gap on left & right)

At fastening the nut for fixing the heater wash, keep the protrusion length of bolt to 10~12mm.

(if under 10mm, water can leak, and if over 12mm, fixture heater can deform)

Thermistor Wash Unfasten the Nut for fixing heater, replace the thermistor, and fasten the nut for fixing heater

At fastening screw for fixing Door AS, be careful so that scratching at the related parts does not happen

: If the scratching happens, it is possible to be claimed about

9 (Dis)assembling

“Door AS”

10 (Dis)assembling

“Motor AS”

Door As

MOTOR AS appearance damage

Be careful about the up/down direction of Door Glass : Keep the indication point of the part code downward.

To avoid the injury on the hand, grip the rim of the rotor

At initiating the assembling operation of the stator, grip the stator and fasten the screw; at unfastening the screw, grip the stator so that it does not fall.

58

본사：서울 마포구 아현동 686

소비자상담실： ( 대표 ) 360-8282 http://www.dwe.daewoo.co.kr